Specific heat capacity method

Question 1

What is the first step to this experiment ?

Answer 1

Wrap the insulation around the base and the sides of the material, heater should fit nicely in the hole of the block

Question 2

What is the second step of the experiment ?

Answer 2

If thermometer has air gap when placed in the hole put a couple of drops of water into the hole to increase thermal contact

Question 3

Step 3 of the experiment ?

Answer 3

If the power of the heater is unknown switch on the power supply and measure the potential difference and current

Question 4

Step 4 of the experiment ?

Answer 4

Keep power supply on and start the timer, measure temp of block every 10 minutes