Deck 63 Flashcards

1
Q

At Hi Rise Office Bldg Fires, when is natural ventilation used

A

When the fire is extinguished. 6.3.8.D

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Define Stack Effect:

A

Noticeable in bldgs over 60 feet.Positive is the upward movement of airNegative is the downward movement of air.Positive Stack effect increases as outside air decreases in relation to the temp of the bldg.Negative Stack = Outside greater than inside. outside air is above 90 degrees.Wind will intensify the stack effect.No Fire Tower for Attack stairs. 6.3.8.D 1-6, Note

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

If Dispatcher informs Battalion that repeater is in use elsewhere, than battalion shall use what?

A

Use Post Radio to Post Radio or “Utilization of UHF side of vehicle repeater radio without use of vehicle cross band side of repeater. Comm Man 12 6.1.2

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What are the components of a Hi Rise Office communications network? 6.2.1.A

A

Department Radio and hard wire with FD Dispatcher.Command Channel using:Post RadioCross Band RepeaterHTxref 6.4.2, Hard wire to ICP from Fire Sector/Branch - Bldg internal phone, FD Sound Powered Phone.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

The Command Channel is used by whom?

A

The command channel shall be used between the Fire Sector/Branch, Forward Staging Area, Forward Triage Area, and SAE Group. Hard wire communications shall also be established. 6.2.1.B.2

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

When the SAE Post is established how many FAST Radios are being monitored?

A

3 ?

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

As the BC at the SAE Post you would know your aide is monitoring what channel?

A

The Command Channel

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

The following responsibilities are for which Chief at a Hi Rise Office Fire - Supervision of Resources Unit Leader. Responsible for Status Check-in and Demobilization. Responsible for situation reports to IC or Operations. Responsible for documentation. Responsible for any technical specialist required on scene. Responsible for Incident Action Plan if required.

A

The Planning Chief.6.3.2.D

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The following responsibilities are for which Chief at a Hi Rise Office Fire Supervision of the Lobby Control Unit. Supervision of the Communications Unit. Supervision of the High-Rise Support Unit. Supervision of the Systems Control Unit. Supervision of the Rehabilitation Unit. Responsible for all activities supporting the incident.

A

Logistics Section Chief 6.3.2.E

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Where is the Forward Staging Area located?

A

Established on the floor below the location of the Fire Sector Supervisor/Branch Director. 6.3.2.F

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Who is responsible to evaluate communications systems for functionality and operability.This includes the use of HTs, hardwire phones, cellular phones, post radios, cross-band repeaters and building repeaters.

A

The Systems Control Unit. 6.3.2.H Designated with the suffix “Y”

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Which unit is utilized to transport equipment via elevator to the Forward StagingArea. If the elevators cannot be used, manage the transportation ofequipment and supplies to the upper floors via the stairways.

A

The Hi Rise Unit. 6.3.2.I A High-Rise Unit shall respond to Any second alarm in conjunction with a 10-77 10-76 and greater alarms in high-rise buildings All underground subway incidents where a signal 7-5 or greater alarm hasbeen transmitted. Comm Man 7.5.11

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Where is the Staging Area located?

A

 Provides an assembly and deployment point from which large quantitiesof personnel and equipment are distributed. Serves as the primary point outside the structure to which respondingresources will report and receive their initial assignments. Located away from buildings to provide personnel safety from fallingglass and debris. 6.3.2.K

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

How many spare SCBA cylinders are kept at the Forward Staging Area?

A
  1. 6.3.6.D
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

When the 2nd Arriving BC, arrives at the location of the 2nd Engine Officers Location, what shall he be equipped with and what transmission shall he make.

A

6.4.3 The Fire Sector Supervisor or Branch Director shall be equipped with:A. At least two HTs.B. SCBA for all members assigned to the Fire Sector/Branch.C. A copy of the floor plan.D. The Fire Sector/Branch log. (Figure 14)E. Post radio1st Transmission = over the primarytactical channel of the handie-talkie radio that the Fire Sector/Branch isestablished and give the location, i.e., “Battalion 9 to all units, Battalion 9 is theFire Sector Supervisor/Branch Director, the Fire Sector/Branch is located on the38th floor near the C stairway”.2nd Transmission = The Fire Sector Supervisor/Branch Director will then contact the ICP via the Post radio on the primary command channel and announce the establishment and location of the Fire Sector/Branch.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Where is the Forward Triage Area located?

A

On a floor below the Forward Staging Area. 6.7.3

17
Q

Class E communication loudspeakers are located where?

A

Loudspeakers operated from the fire command station, which are located on all floors, in all elevators and in all stairway enclosures.7.2.1.BA public address system to all floors, elevators and stairways either selectively or collectively. 7.2.2.D

18
Q

The Fire Command Station shall include Two-way communications between the fire command station and the following:

A
  1. Floor warden stations.2. Mechanical control center.3. Elevators.4. Air handling control rooms.5. Elevator machinery rooms.7.2.2.C
19
Q

T?F A floor warden station shall be able to make announcements over the loudspeaker system on the floor where it is located.

A

True, as well as, Capability to activate a visual and audible signal at the fire commandstation. AND Two-way voice communications with the fire command station. 7.2.3

20
Q

A manual fire alarm sending station shall be able to:

A

A. Automatic transmission to the Fire Department via a central station.B. A visual and audible signal at the fire command station, mechanical controlcenter and the regularly assigned location of the fire safety director.C. Sounding of the alarm ON THE FIRE FLOOR AND THE FLOOR ABOVE.7.2.4

21
Q

At each elevator landing, the activation of the detection device shall cause:

A
  1. Recall the elevators.2. Sound the fire alarm signal on the fire floor and the floor above.3. Cause a fire alarm signal to be transmitted to the Fire Department via a central station.4. Cause a fire alarm signal to be sounded at the fire command station, the mechanical control center and the regularly assigned location of the fire safety director.5. Stop the air supply into and the return air from the floor where activated.6. Activate the air exhaust fans and dampers in the smoke shaft or the pressurizing fans in the stair enclosure.7. Unlock the doors on the locked fail safe system.7.2.5
22
Q

Define, Mechanical Control Center

A

A location within a building where equipment is located for the monitoring of the building support systems. It has limited ability tocontrol some of the building support systems. It may or may not be located on the same floor as the mechanical equipment rooms (MER). Glossary

23
Q

If the HVAC detection system activates what shall be accomplished?

A

All the items of an elevator detector activation except the recalling of the elevators. 7.2.6

24
Q

Which two activations of approved detection devices will recall the elevators?

A

Elevator landing detector activations and Sprinkler Water Flow Alarms. 7.2.5,6

25
Q

The communication features of the class “E” system can be used for two-way communications with:

A
  1. Elevators.2. Fire Pump room.3. Mechanical control center.4. Air handling control center.7.3.2.C