-x-Task Sharing by Flight Phase-x- Flashcards
All PM tasks before pushback
Walkaround ATIS obtain Clearance obtain EFB preparation check FMS preparation check Oxygen test if required Weight and balance LMC
All PF tasks before pushback
Checklist Panel scan Oxygen test if required FMGS preparation Weight and balance Takeoff safety brief Ask for before start checklist down to the line
When ready to push back tasks
PF - Clearance from ground crew “Ready for your checks” PM - Clearance from ATC PF - BMNAPT PM - Mobile phone and PED PF - “Below the line” PF - “Cleared to push and start, park brake set” PM - When moving, elapsed time start, and transponder to auto
BMNAPT
Beacon - ON Mobile phone/PED - OFF NW STRG DISC - As required ACCU Pressure - CHECK Parking Brake - On THR Levers - IDLE
After start flow
PF Engine mode sel - NORM APU Bleed - OFF WING and ENG Anti ice - As RQRD APU Master - As RQRD Y ELEC PUMP - As RQRD PM GND SPOILERS - ARM RUD TRIM - ZERO FLAPS - SET PITCH TRIM - SET Both - Check ECAM status BRAKE FANS - CONSIDER PF - “Cleared to disconnect, hand signals on the left with the pin”
Single engine taxi PF tasks
Engine mode sel - NORM APU Bleed - OFF ENG and WING anti-ice - AS RQRD Y Elec Pump - ON (APU Master - Leave on)
Single engine taxi PM tasks
In a straight line, after PF announces engine 2 start: Y ELEC PUMP - OFF APU BLEED - ON ENG MODE SEL - IGN/START ENG 2 START - ANNOUNCE ENG MASTER 2 - ON ENG IDLE PARAMETERS - CHECK ENG MODE SEL - NORM APU BLEED - OFF ENG and WING ANTI-ICE - AS RQRD APU MASTER - AS RQRD Both check ECAM status, then do after start checklist
Taxiing to the runway tasks
“Clear left side”, “Clear right side” PF - Taxi light on BRAKES - CHECK FLT CTL - CHECK PM - AFWET PEDS Brief Before take off checklist down to the line
AFWETT
AUTO BRAKE - MAX FLIGHT INSTRUMENTS AND FMAS - CHECK WX RADAR and PWS - AS RQRD ECAM T/O CONFIG - PRESS T/O NO BLUE - CHECK TRANSPONDER - CHECK
At holding point to enter runway, what do you do before and after receiving clearance?
Before: CABIN REPORT - RECEIVE BRAKE TEMP - CHECK BRAKE FANS - OFF SLIDING TABLES - AWAY Get clearance, then: Both - APPROACH PATH CLEAR EXTERIOR LIGHTS - SET ENG MODE SEL - AS RQRD TCAS - TA/RA ANTI-ICE - AS RQRD PACKS 1+2 - AS RQRD “Below the line”
ATEAPES
Approach clear TCAS - TA/RA ENG MODE SEL - AS RQRD ANTI-ICE - AS RQRD PACKS - AS RQRD EXTERNAL LIGHTS - AS RQRD Stow table
After Landing scan
PM Landing lights - RETRACT Nose lights - TAXI Strobe lights - AUTO Other lights - AS RQRD PF GND SPLRS - DISARM PM WX RADAR and PWS - OFF ENG MODE SEL - NORM FLAPS - RETRACT TCAS - STBY/XPNDR PACK 2 - AS RQRD (COVID has leave PACK 2 ON) APU - START (When appropriate) ANTI-ICE - AS RQRD FCU - DESELECT GPWS LDG FLAP 3 - OFF
Parking scan
CM2 “Cabin Crew disarm doors for arrival” EXTERIOR LIGHTS - AS RQRD ANTI-ICE - OFF Y ELEC PUMP - OFF Monitor CM1 flow ELAPSED TIME - STOP TRANSPONDER - STBY/CODE 2000 PACK 1+2 - OFF CTR TK FUEL PUMPS - OFF IRS PERFORMANCE - CHECK FUEL QUANTITY - CHECK STATUS - CHECK BRAKE FAN - AS RQRD APU BLEED - AS RQRD (COVID on) EXT POWER - ON APU - AS RQRD (COVID on) Parking checklist
Securing the aircraft
EFB - OFF DUs - DIM FUEL PUMPS - OFF ADIRS 1+2+3 - OFF OXY CREW SUPPLY - OFF MAINT BUS (The bean) - ON IF GPU AVAIL APU BLEED - OFF APU MASTER - OFF EMER EXIT LIGHT - OFF NO SMOKING - OFF EXT PWR - AS RQRD BAT 1+2 - OFF
Flaps Zero in the climb tasks
PF “Flaps zero” PM FLAPS ZERO - SELECT GND SPOILERS - DISARM EXTERIOR LIGHTS - SET Also when requested by PF, Seat belt signs cycle and landing lights retract