PASSENGER ALARM

Question 1

How do you if PASSENGER ALARM is activated?

B92?
B2007?

Answer 1

Via an audible noise and visual indication

On B92 —> Red light above PA
On B2007 —> Open Door Indicator on ceiling

Question 2

How do you find an activated PA:

On B92?
On B2007?

Answer 2

B92 —> check all vehicles
B2007 —> Fault on HMI

Question 3

Where is the Passenger Alarm activation found on the disabled area on

B92?
B2007?

Answer 3

B92 —> red light above PA
B2007 —> on ODI by B5 and B6

Question 4

How does control know that a PASSENGER ALARM has been activated?

Answer 4

Fault received via the inductive loop through the REMOTE MONITORING SYSTEM

Question 5

On a B2007, what else happens when a PA is activated?

Answer 5

CRT receives emergency calls on radio

Question 6

When PA IS ACTIVATED and you are in the following predicaments, what should you do?

1. In motion?
2. Stationary?
   3, Within 10 seconds of moving from station?

Answer 6

1.Go to next stop/CAZ boundary, then reset
2. Reset before departing
3. Stop by inhibit at DCP, then reset

Question 7

How do you reset a PASSENGER ALARM

Answer 7

1. WHEN PA IS ACTIVATED, CONTACT THE CONTROLLER TO ADVISE THEM
2. USE PA AT EDP OR ARTICULATED AREA TO SPEA TO THE PASSENGER
3. AT EDP, TURN SWITCH BY PA HANDSET FROM PA TO INTERCOM
4. WHEN AT PLATFORM LOCATE THE ALARM AND RESET USING THE CARRIAGE KEY
5. IF SOUND CONTINUES  MORE THAN 1 ACTIVATED
6. IF ASSISTANCE IS NEEDED CONTACT CCC
7. IF NO ASSISTANCE IS NEEDED, CONFIRM RESET WITH CCC