Systems Quiz FIRE Flashcards
What happens when you push the Master Fire Warning (FIRE WARN) Lights?
1 Extinguished both master FIRE WARN lights
2 Silences the bell
3 Silences the remote fire warning APU horn
4 resets system for additional warnings
The indications of an engine fire are?
1 Fire warning bell
2 both master FIRE WARN lights illuminate
3 the related engine fire warning switch illuminates
4 all related engine overheat alert indications illuminate
The indications of an APU fire are?
1 Fire warning bell
2 both master FIRE WARN lights illuminate
3 APU fire warning switch illuminates
4 APU automatically shuts down
5 Wheel well APU fire warning horn sounds
What will pulling up on the engine fire warning switch do?
1 arm one squib on each fire bottle
2 close fuel, hydraulic shutoffs, and engine bleed air valves
3 disable thrust reverser
4 trip the generator control relay
5 allow the fire warning switch to be rotated
The indications for the FAULT/INOP test are?
1 both MASTER CAUTION lights illuminate
2 OVHT/DET system annunciator lights illuminate
3 FAULT light illuminates
4 APU DET INOP light illuminates
CAUTION/OVHT/FAULT/APU
Indications for the OVHT/DET test are?
1 fire warning bell
2 both MASTER CAUTION lights illuminate
3 both master FIRE WARN light illuminate
4 OVHT/DET system annunciator lights illuminate
5 both engine fire warning switches illuminate
6 APU fire warning switch illuminates
7 both ENG OVERHEAT light illuminate
8 WHEEL WELL fire warning light illuminates if AC power is available
FIRE/ENGINES/APU/WHEEL
What are the primary control surfaces?
Rudder - Yaw
Elevator - Pitch
Ailerons - Roll
What are the 3 secondary control surfaces?
Slats
Spoilers
Flaps
True or False: The rudder can be powered by the standby hydraulic system if system A and B fail?
True
Which flap position provide more lift? Which flap position provide lift and a lot of drag?
Trailing edge flaps 1-15 provide increased lift. positions 15-40 provide lift and drag. 30-40 are used for landing
True or False: In the event of a failure of System B and PTU operation, the leading edge devices cannot be extended by the standby hydraulic system?
False. They can be
This is used to fully extend the leading edge slats when approaching a stall. If the flap lever position is between 1-5, this will command full extension.
Autoslat Control Valve
Used to power torque tubes to mechanically extend/retract the TE flaps. Normally powered by hydraulic pressure from System B. During alternate flap operations the ___ can be operated by an electrical motor.
PDU Power Drive Unit
Meaning of the flight control LOW PRESSURE lights?
Indicates low hydraulic pressure to ailerons, elevator, and rudder.
FLAP LOAD RELIEF light indicates?
If flaps are set at 40. flaps will automatically retract to 30 due to excess airspeed. And so On… 30->25
