Rear seat/NFP Flashcards

1
Q

Before lift/landing Cx

A

ASF - As req
PFD - “Set, Nil P3”
OEI - “SUP set”
M/ARM - OFF (as req)
Firing safety - Safe, guarded
Weapon - deactivated
Gun - Stowed
Laser - As req
EWS - As req
IFF - Code set and transmitting
Park brake - As req
Tail wheel - Locked

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Hover Cx (6)

A

Flight controls/CofG - Normal
Park brake - OFF
Hover Performance - #PMI in reserve, Cat # confirmed
RADALT/DH - Valid, tested
LRFD - Check
Weapon system - Check

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

After T/O or missed approach checks:

A

ASF - As req
OEI - SUP set
M/ARM - As req
DA/DH - Set
ANT.LT - ON (E)
STBY AI - Attitude correct (IFR)
STBY IAS/ALT/VSI - Indications correct (IFR)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Explain the RMS harmonisation process from the rear seat:

A
  1. MFD 3 ……………………………………………………………………………………………………. VIS IR.
  2. MFD 4 …………………………………………………………………………………………………… VIS TV.
  3. RMSCP, HARMO button …………………………………………………………………………….. Press.
  4. Harmo status …………………………………………………………………………………………… Monitor.

If harmonisation is unsuccessful:

  1. RMS Harmonisation Failure ……………………………………………………………………… Perform.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

How long does RMS harmonisation typically take and what is the maximum time?

A

Typically take 20 sec, should be completed by 40sec

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

How does the HARMO button look if successful vs unsuccessful?

A

Successful: Switch will be blank with no lights illuminated
Unsuccessful: “HARMO” will be illuminated the same as at the start

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What is required prior to starting RMS harmonisation?

A

The IR camera must be cooled sufficiently

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

When and how should the rear seat select the IR camera to start cooling?

A

Once PWR turns on, select the IR switch to ON

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What are the indications for the status of the IR camera during cooling?

A

IR camera OFF: No lights
IR camera cooling: Bottom light flashing green
IR camera cooled and ready: Bottom light solid green

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the process for pressurising the RMS?

A

Pin - Remove the pin and place in pin bag
Cock - Full open then back off 1/8th turn
Pressure - Confirm in green zone

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Between what attitudes does the rear seat lose visibility due to the bar?

A
How well did you know this?
1
Not at all
2
3
4
5
Perfectly