HGST 2018 Flashcards
GT-I.3 (GST and G-COFT/E) must be successfully completed by all units with a gunnery program at least______________
Semi-annually
All aircrew members must complete the following prerequisite training events prior to conducting live-fire aerial gunnery:
a. Aircrews must be current on GT-I.3, based upon the individual’s semi-annual ATP requirement in chapter 2.
b. Individuals who are newly assigned, or whose GT currency has lapsed are required to earn a GO on GT-I.3 prior to conducting live-fire gunnery.
(3-04.45 pg 6-3)
Rockets are being loaded into your left outboard rocket pod, zone E. How many rockets can be loaded into this zone?
3
During the Weapons Operational Check, you WAS Rockets and observe this rocket steering cursor. What does this indicate?
Ground Stow -10 P. 4-29
The minimum range to target when firing Flechette rocket is_______meters. The effective range withMK66 rocket motors is ______________. Effectiveness is reduced with ranges greater than ____________.
800
1 to 3Km
3Km
Based on the TADS image below, what type of Rocket has the CPG selected?
Illumination
The message 6IL NORM 8 is located in the _________________________ section of the High Action Display.
Weapon Status -10 P. 4-31
The engagement process is a systematic fires cycle and a continual process on any mission. The 5 five tenets are:
Detect, Identify, Decide, Engage and Assess
(TC 3-04.45 pg. 11-1)
The three target-effect standards for armed helicopter engagements are?
suppression, neutralization, and destruction
________________________ is the process of attaining an accurate characteristic and discriminatory aspect of detected objects on the battlefield.
(TC 3-04.45 pg. 12-1)
Target identification
Based on the Weapon Page shown above: The CPG has selected TRN as an Acquisition Source. TRN stands for______________________.
Terrain Point -10 P. 4-40
On the Weapon Page shown above: R2 allows the Missile Mode to be changed. When Mode is selected there are three possible Missile Modes 1.____NORM_________ 2.____________________ 3. _____________________
RIPL MAN -10 P. 4-101
During a Rocket Engagement the Pilot observes an ACCEL LIMIT message in the High Action Display. Is this a Safety or Performance Inhibit?
SAFETY -10 P. 4-38
Can this be overridden by placing the Weapon Trigger to the second detent? (ACCEL LIMIT)
NO -10 P. 4-105
_____________________ is caused by the motion of the helicopter as the projectile leaves the weapon.
Angular Rate Error
Referencing the Gun Duty Cycle: For Burst Limit Settings other than 50, the cycle can be generalized as no more than __________ rounds fired within __________ seconds before allowing the gun to cool for __________ minutes, after which the cycle may be repeated.
300 60 10
-10 P. 4-91
The gunner’s triangle is a logical sequence which standardizes the engagement method, in the order of- _______,______,_______,________,_____________. This method ensures that the firing crew member uses a complete cross-check, while verbalizing the engagement parameters for the opposite crew member to maneuver the aircraft appropriately.
target, heading, range, store, weapons employment
In reference to Team Employment Techniques: The ___________________ Pattern allows for unpredictable direction of attack, good target coverage from multiple directions, and continuous fire on the enemy. The pattern may be modified to adapt to terrain and the number of firing passes required.
CLOVERLEAF
ATM 4-218
While flying as a wingman and preparing to conduct a CCA, flight lead briefs you using the TPM-R format. What does TPM-R stand for?
TECHNIQUE, PATTERN, MUNITION, RANGE
ATM 4-249
Gator 16, the on-scene commander, advises you that he has taken small arms fire from a small building. He has authorized you to destroy the building with a missile. You determine a N-model HELLFIRE is your weapon of choice. What is the minimum range you can fire this missile?
800m
AWR 2007D-A05
You acquire the building in Narrow FOV FLIR and observe ‘tic marks’ on the end of your LOS. What do these ‘tic marks’ on your LOS indicate?
LMC is On
-10 P. 4-28
As your aircraft aligns with the target, you have a laser range of 1335 meters, airspeed is 64 KTAS and you are 740’ AGL. You have a solid LOBL constraints box, with no inhibits. Do you meet the criteria necessary to engage the target?
YES
What are the nine laser limiting factors:
Backscatter, Boresight Error, Spot Jitter, Beam Divergence, Attenuation, Overspill, Underspill, Podium effect, and Entrapment.
(TC 3-04.45 pg F-4)
Gator has once again received small arms fire directed on his position. He reports enemy nearby his position to the west. What is the Danger Close distance if you decide to fire 30mm at a range of 1000m.
75m
JFIRE P. 110
The M789 nominal burst radius is ___ meters; however, the lethal fragment impact pattern is dependent upon the surface conditions, impact angle, velocity, and the target type
4
Aircraft control is most critical when engaging targets with rockets. The preferred sequence, known as the four T’s is _______________, _______________, _______________, and _______________.
Target, Torque, Trim, Target
LOAL HI will clear a _______ mask with a __________standoff.
( LBHMMS Student Handout pg D-53)28.
1,000 ft
1,500 meter
( LBHMMS Student Handout pg D-53)28.
What are the four modes of fire?
Hover fire, Moving fire (Equal to or greater than ETL but less than 40 KTAS), Running fire Greater than 40 KTAS but less than Vne), Diving (pitch attitude 10 degrees below the horizon or greater and 40 KTAS to Vne)
(TC 3-04.45 pg. 14-2)
While preparing for a Diving Fire engagement, you determine your ‘hard-deck’ is 500’ AGL. To ensure you don’t descend below this altitude you desire for the “ALTITUDE LOW” audio to enunciate when your altitude reaches 600’ to allow sufficient time to recover. In order for this audio message to announce at 600’ you set your LO Bug to __________.
660’
-10 P. 2-98
A flashing asterisk in the *XXXX message indicates
Receiving multiple target returns (–10, pg 4-33)
T / F If the DTV boresight fails, the FLIR boresight will not be performed.
TRUE
-10 P. 4-80
While getting a mission update in the TOC, you notice the graphics for an upcoming mission. What does this symbol represent?
ABF
Unfortunately, it has become necessary to Jettison your Armament Wing Stores. The maximum airspeed for Wing Stores Jettison is __________ KTAS.
130 KTAS
The minimum altitude for auto ranging is approximately _____. AGL with a __________look down angle.
33 ft
one-degree
If you have been operating the MTADS/MPNVS on the ground for __________________or longer, perform a _________ before takeoff. -10-2 pg 8-13
15 minutes
SANUC
The M789 HEDP projectile is an ______________and ____________________ round capable of defeating light armored vehicles. (TC 3-04.45 pg. B-18)
anti-materiel
anti-personnel
SPARKLE
Mark / marking target by IR pointer or Platform is capable to IR point
HANDSHAKE
Video data link established. Opposite of HOLLOW
ROPE
Circling an IR pointer around an aircraft to help the aircraft identify the friendly ground position
WINCHESTER
No ordnance remaining.
The three conditions that will cause a REMOTE message to be displayed in the HAD are the following:
1) the firing ACFT’s LRFD code does not match the requested (PRI) code, 2) the selected sight is HMD, 3) the laser if off.
- Using the TSD COORD Page listed above, to set your ACQ Source to T03 would you select L3 or R3?
L3
What is the azimuth and distance to T07?
027° / 15.0KM / 8.1NM
The TADS internal boresight should be accomplished _______________ every _____________ hours of flight.
Twice / 2.5
-10 P. 4-44
The M278 IR Illumination (covert) warhead will provide IR light for____________________.
three minutes
The Operator’s Manual indicates that during the Pre-flight inspection it may be necessary to rotate the Hellfire launcher to the ARM position. What would be the reason for this?
If icing conditions exist
-10 P. 8-3
IAW the checklist, During preflight and after all live fires, when the AWS has been used, what will the crew inspect for?
Cracks in the barrel
-10 P. 8-18
The missile seeker has a ________degree seeker limit from the missile centerline
+/- 30
What does this missile icon indicate?
Missile is unlatched
-10 P. 4-99
Missile constraints box driver:
a. LOBL – Missile Seeker
b. LOAL DIR – selected LOS
c. LOAL LO or HI – target coordinates stored in the WP in the acquisition selection (B5).
LBHMMS Student Handout pg D-18
