KSQR- Execution Part 1 Flashcards
what additional PPE might be required for the following tasks:
- Disconnecting acid hoses from tote tanks –
- Disconnecting N2 equipment after a foam job
- Disconnecting acid hoses from tote tanks – chemical gloves, face shield, respirator
- Disconnecting N2 equipment after a foam job – leather gloves
what additional PPE might be required for the following tasks:
- Strapping a 400 bbl upright tank –
- Being near any sort of silica dust during pumping of sand
Strapping a 400 bbl upright tank - fall protection
- Being near any sort of silica dust during pumping of sand – Dust mask, safety glasses and/or goggles
what additional PPE might be required for the following tasks:-
Strapping a horizontal flat head tank with produced water
and
Performing lab tests
- Strapping a horizontal flat head tank with produced water – Face shield, rubber gloves
- Performing lab tests – Possible face shield, chemical goggles, rubber gloves
what additional PPE might be required for the following tasks:
- Pumping corrosive completion brines
– Slicker suit (Tyvek), rubber boots, chemical gloves, face shield
Which SLB QHSE standard covers PPE?
Answer: QHSE Std. 3
What is the maximum height at which we can work without fall protection?
Answer: We need to be wearing a harness for anything over 6 feet in height.
You are about to start a “sim-ops” job on a frac location which is a large pad well with a drilling rig, wireline and frac equipment on the same pad. This is going to be a high-rate/high pressure job and is expected to possibly screen-out. Who needs to be present at the pre job meeting?
o SLB crew
o Wireline crew
o Company man (both frac and drilling operations)
o Flowback personnel if any are on location
o Any one else who may potentially be on location while pumping
Give examples of some contingency plans that might be implemented during a stimulation/frac job.
o Discuss emergency escape routes and muster points
o If we are pumping an energized fluid, has everyone picked an escape route as they will not be able to see if the cloud of N2 or C02 is flowing out?
o If we have to shut down a pump because something goes wrong, do we have someone who is able to isolate it and open another if one is available?
o In case an emergency shutdown is required, who is responsible for closing the wellhead?
o If someone is injured, what are the first steps you will take and do you know who to call?
o What happens if we screenout early and the emergency shutdown devices fail to operate?
o What happens if the computers shut down during the job?
Which direction are the wings on the treating iron supposed to be facing when rigged up?
Answer: With the wings towards the well
How many chicksans are to be used when making a direction AND elevation change during treating iron rig-up? Why do we do this?
Answer: 3 minimum – 2 x two-way chicksans and 1 x three-way chicksan. This is done to allow 100% line flexibility.
