KSQR-Design part 2 Flashcards
Who is deemed knowledgeable when performing load out volumes as well as additive calculations?
This should be someone who is familiar with the load out volumes and add calculations as well as has some sort of ownership of the job (Job Supervisor, Engineer..) It should not be done by the new greenhat without a mentor checking on the work performed. It should also be done in such a way that “clear-evidence” is placed in the job packet.
In your district, how are slurry volumes and additive calculations verified prior to job loadout?
- Check FracCADE or Wellbook numbers by hand or against the mass balance (or vice versa)
- Peer review
You are going on a job that requires a blended additive such as a crosslinker, how do you verify that this was done properly?
- Verify the paperwork from the bulk-plant (MSDS, TC Coded paperwork, etc..)
- Visually check the paperwork with the actual load (review blending sheets if available)
- Again, need to have clear evidence in the job packet that the proper procedures were used.
What is the proper way to take a proppant sample from a bulk container?
Answer: Using a sample catching “wand”, take a sample at the bottom, middle, and top of each container.
Which WS safety standards require certification in QUEST for all WPS field engineers and supervisors? How long is the certification good for?
- 5, 18, 23, 28, 30. Std. 1, 9, 11, and 17 may be required in certain districts also
- 1 year (2 years on std. 9 and 11)
Which WS safety standards require certification in QUEST for all crew members?
Answer: 5, 18, 23
This is the only operator required on location to have a special certification for operation of their piece of equipment.
Answer: The crane operator must have a current crane certification to operate the crane
What does SIPP stand for?
Answer: Schlumberger Injury Prevention Program
How do you establish that the operators are confident and have done the same or similar types of jobs?
Asking EO and/or previews supervisor about EO expirience, asking him if he feels coffident running the equipment by himself and if he has done it before
What does STEM stand for?
Answer: Standard Equipment Maintenance
Which units are required to have STEM 1 form?
Answer: All units are required to have a STEM 1 form, including the white vehicles
What types of things are checked during a STEM I?
Answer (numerous answers): Tire pressure, lights, oil levels, horn, etc… pre trip
How often is a STEM II required?
Answer: 400 hours, 180 calendar days, 6000 miles
