AVSOFT Navigation Exam Questions Flashcards
A marker beacon test is performed ?
On the VHF navigation particular page on the ARCDU
When a navigation source knob reaches the last selectable source continued knob rotation ?
Will result in no change to the navigation source
Pushing and holding the DATA button on the EFIS control panel ?
Removes any displayed navigation aids and airports from the display
The 10 nearest VORs can be displayed on the MFD navigation display by ?
Pressing the DATA button on the EFIS control panel
Bearing needles for ADF2 can be displayed ?
On both PFDs and MFDs
The maximum range able to be displayed on the MFD navigation display is ?
240 NM
On the ground the radar forced standby (FSBY) mode can be manually overridden by pressing the STAB pushbutton ?
4 times within 3 seconds
When in the ILS mode one dot of CDI deflection on the EHSI indicates a course deviation of ?
1.25 degrees
In order to hold both DMEs using the #1 ARCDU ?
Press DME HOLD, press the side key for the offside VOR/ILS and press DME HOLD again
When the ADF is put into antenna (ANT) mode ?
The needle will point to the right wing (90 degree relative bearing)
If WX is selected on the weather radar control panel before the system has warmed up the MFD will display ?
WX WAIT
DME information is displayed ?
Displayed at the bottom of the PFD and MFD navigation display when DME data is available
When the aircraft is powered up ?
All of the above
The navigation sources default to the on-side VOR/ILS
The selected courses reset to 360 degrees
The heading bugs reset to 360 degrees
Which of the following inputs is not provided to the FMS to determine the Best Computer Position (BCP)?
Acceleration data
The LOC MISMATCH message on the flight mode annunciator indicates a mismatch between ?
ILS1 and ILS2 receiver outputs
