Rwy/Perf Change and Before Takeoff Knowledge

Question 1

When is the Runway and Performance Change Check accomplished?

Answer 1

Prior to Before Takeoff Check

Question 2

What must be completed prior to the CP calling for the checklist?

Answer 2

Required Tasks

Question 3

What is the response if there are no changes?

Answer 3

FO: RUNWAY PERFORMANCE CHANGE CHECK COMPLETE, NO CHANGE

Question 4

What should the CP consider when completing the checklist?

Answer 4

Stop the Aircraft

Question 5

After completing the Rwy and Perf Change Check and Before Takeoff Check, you receive a change. What is required?

Answer 5

They BOTH must be completed again

Question 6

What items are checked for the FMS task?

Answer 6

Verify amended clearance, runway, and routing changes

Question 7

What items are checked for the Takeoff Data Task?

Answer 7

1) V-Speeds
2) Set SPD bug for V2+20
3) Verify N1 thrust setting (Norm or Flexed)

Question 8

What items are checked for the Trim Task?

Answer 8

1) Stab trim

2) Aileron and Rudder trim centered

Question 9

What items are checked for the Flight Instrument Task?

Answer 9

1) FMA is clear
2) DH/MDA Clear
3) NAV Source
4) Alt Preselect to assigned Alt
5) HDG Bug set for DEP
6) FMS Map Page selected

Question 10

What items are checked for the Flaps task?

Answer 10

FO: ED-1 Proper flap position

Flap lever in appropriate position

Question 11

What items are checked for the Bleeds and APU Task?

Answer 11

Configured appropriately

Question 12

What items are checked for the Takeoff Briefing Task?

Answer 12

Elements specific to the runway or perf change

SE DEP/First Fix/Any changes to Cleared alt or speed

Question 13

What does the CP and FO check and state for Flaps response?

Answer 13

CP: SOURCE DATA FLAPS ()/() SET
> Checks ED-1
FO:(_) CONFIRMED
>Checks ED-1

Question 14

What items must be included in the Takeoff Brief?

Answer 14

Elements specific to the runway or perf change

SE DEP/First Fix/Any changes to Cleared alt or speed

Question 15

When is the Before Takeoff Check to the LINE conducted?

Answer 15

Holding short

Question 16

When is the Below the Line checklist conducted?

Answer 16

Cleared onto Runway

Question 17

What items is the FO required to check for the Takeoff Data task?

Answer 17

1) APU/Bleed Air
2) Perf Data is set for DEP RWY
3) First waypoint and initial altitude are properly set

Question 18

What items are checked for the Takeoff Data when reading the checklist?

Answer 18

1) DEP Runway
2) RNAV/HEADING
3) ALTITUDE

Question 19

Where does the Captain verify flap setting?

Answer 19

On ED-1

Question 20

How does the Captain verify flap setting?

Answer 20

ED-1 and Flap Lever

Question 21

Where does the FO verify flap setting?

Answer 21

Source Data

Question 22

How does the FO verify flap setting?

Answer 22

Source Data and ED-1

Question 23

What message is checked when the FO reads TAKEOFF CONFIG on the checklist?

Answer 23

TAKEOFF CONFIG OK

Question 24

When required, during the FO below the line flow, how is the radar configured?

Answer 24

TILT +6

AUTO TILT OFF

Question 25

While reading the checklist, what elements are checked under the CAS read-and-do item?

Answer 25

• Appropriate messages for aircraft config

- BRAKE TEMP within limits

Question 26

Is takeoff permitted with a BMTS indication of 6?

Answer 26

Reference QRH Vol 1

Question 27

Is takeoff permitted with a BMTS indication >7?

Answer 27

Prohibited until values decrease to allowable levels