Annex 14 | Lights Flashcards
With the PAPI system, a correct approach path will be indicated as -
2 white lights and 2 red lights.
With the PAPI system, a slightly low approach path will be indicated as -
1 white light and 3 red lights closest to the runway
With the PAPI system, the red lights as you progressively fly lower, will increase from the -
Side closest the runway.
Runway threshold identification lights shall be located-
Runway threshold identification lights shall be flashing-
And should be visible only -
symmetrically in line with the threshold and approximately 10 m outside each line of runway edge lights
White lights
In the direction of approach
Runway edge lights are provided for a
runway intended for use -
Runway edge lights should be provided on a runway intended for take-off with an operating minimum below an RVR of the order of -
Runway edge lights shall be placed along the -
Runway edge lights placed not more than -
Runway edge lights are what colour? Except between what two points?
A section of the lights 600m or one-third of the runway length, whichever is less, at the remote end of the runway from -
at night or for a precision approach runway intended for use by day or night
800m by day
full length of the runway and shall be in two parallel rows equidistant from the centre line.
3m from the runway edge
White, except if a displaced threshold exist, between the start of the runway and the displaced threshold the lights shall be red.
the end at which the take-off run is started, they may be yellow.
Runway end lights shall be provided for a runway equipped with -
Runway end lights shall be placed on a line at -
and;
not more than -
Runway end lights shall be fixed unidirectional lights showing -
Runway edge lights
Right angles to the runway axis as near to the end of the runway as possible and;
3 m outside the end.
red in the direction of the runway.
Runway centre line lights shall be provided on a-
Runway centre line lights shall be variable -
Runway centre line lights shall be alternate -
Runway centre line lights shall be -
precision approach runway category 2 or 3
White from the threshold to the point 900m from the runway end.
red and variable white from 900m to 300m from the runway end
red from 300m to the runway end.
Rapid exit taxiway indicator lights should be provided on a runway intended for use in runway -
In each set, the lights shall be located ? apart and the light nearest to the runway centre line shall be displaced ? from the runway centre line -
Rapid exit taxiway indicator lights shall be fixed unidirectional -
visual range conditions less than 350m and/or where traffic density is heavy
2m and 2m
Yellow lights
Stopway lights shall be provided for a stopway intended for use at -
Stopway lights shall be placed fixed unidirectional lights showing -
Night
red in the direction of the runway
Taxiway centre line lights on a taxiway other than an exit taxiway and on a runway forming part of a standard taxi-route shall be fixed lights showing -
Green
What are stop bar lights?
Are stop bar lights controlled by ATC?
A series of unidirectional red lights, embedded in the pavement, right angles to the taxiway centreline, at the associated runway holding position
Yes
What is the purpose of runway guard lights?
and the colour?
To warn pilots, and drivers of vehicles when the are operating on taxiways, that they are about to enter an active runway.
Yellow
The colour of intermediate holding position lights?
Yellow
The only signs on the movement area utilising red will be -
mandatory instruction signs.