Warning Systems Atlas Flashcards
Can a landing gear configuration warning due to flaps in the landing position (either 25 or 30) without the gear being down and locked be cancelled by pushing the master warning switch?
No, landing gear can figuration warnings can only be cancelled by correcting the situation that caused the warning. In this case either lowering the gear or going around and selecting flaps 20
Can a red warning EICAS alert message be cancelled with the RECALL/CANCEL switches?
No, a red warning alert message will only go away when the condition causing the warning is resolved
Will pushing the master warning/caution reset switch silence the warning siren for an auto pilot disconnect?
No, the auto pilot disconnect switch on the pilot yoke must be pressed
What EICAS indications are inhibited during takeoff, beginning at rotation?
Fire bell and Master warning lights
When is the caution light inhibited during take off?
80 kn
TERIN, TERAIN, PULL UP voice annunciations sound when how many seconds from projected impact with terrain??
20 to 30 seconds
Can you cancel a status message with the EICAS CANCEL switch?
No, status messages can be cleared by maintenance, or by following the supplemental procedures for status message clearing during pre-flight
What causes the standby engine indicator to activate if the standby engine indicator selector is in AUTO?
A failure of both EICAS CRT’ S
What happens if the EICAS status page is displayed and you push the engine display switch?
Secondary engine parameters replace the status page
Which warning is indicated by a siren?
Cabin altitude warning
Which aurals are associated with the caution alert?
Voice and Beeper
What action is required to display the second page of the EICAS alert messages?
Push the cancel switch
When does the takeoff inhibit of the master warning/caution light end?
20 seconds after nose gear strut extension or 400 feet, which ever occurs first
Which of the following can appear on the EICAS status display?
Flight control position
Status messages
BTMS – as installed
What is indicated by the EICAS status cue?
New status message exists