***767 Flows (FM 11) Flashcards
Checklist
- BEFORE START (below the line)
- AFTER START Flaps _______
- BEFORE TAKEOFF (below the line, RWY_____)
- AFTER TAKEOFF
- INRANGE
- APPROACH
- BEFORE LANDING
- AFTER LANDING
- SHUTDOWN
Before Start (Belowthe Line) (CA)
- Hydraulic panel - Set (if tow bar is connected, node gear steering must be locked out)
- RT ELEC DEMAND pump selector - AUTO
- Center 1 and 2 ELEC PRIMARY pump switches - ON
- LT ELEC DEMAND pump selector - AUTO
- Center AIR DEMAND pump selector - AUTO
- Fuel panel - Set
- LT and RT FUEL PUMP switches - ON
- if there is fuel in the center tank*
- Center FUEL PUMP switches - ON
- LT and RT FUEL PUMP switches - ON
Starting Engine
Ground Crew “area clear, cleared to start engines”
FO: PACK CONTROL selectors - OFF
EICAS messages
L PACK OFF
R PACK OFF
CANCEL switch - Push (Verify that messages are canceled)
“START _____ ENGINE” (Left or Right)
Captain starts the chronograph when the F/O selects the engine start selector.
Verify that oil pressure increases
Verify that EGT increases and stays below the EGT limit
EGT - red tick mark no longer present), start the other engine
CA or FO start clock after the (red) EGT Start Limit Line no longer displays
After Start Flaps _______ (CA)
None
“After Start Checklist” “Flaps 5”
if de-icing/anti-icing is-required, do not configure Flaps and Trim for takeoff until de-ice/anti-ice is complete
Before T/O (CA)
- Rudder - Check
Before T/O, Below The Line, RWY_______
- RWY Turn-Off Lights - ON
2. Nose Gear Light - ON
After T/O (PM)
- Gear - UP, OFF
- Flaps - UP
- **Above 18,000’, turn OFF
- RUNWAY TURNOFF
- LANDING
- NOSE GEAR
- WIND
In-Range (PM)
- Lights - Set
- RUNWAY TURNOFF - ON
- LANDING - ON
- WING - ON
- Altimeters - Set
- Recall - Check
NOSE GEAR light when cleared to land
Before Landing (not a required flow)
- Gear Down
- Flaps 20°
- Arm Speed Brake
After Landing (CA)
- Speed brakes - DOWN
Shutdown (CA)
- Parking brake - Set
- Engine anti-ice - Off
- RT Fuel control switches - CUTOFF (verify SPAR VALVE light ON/OFF)
- Electrical power - Set
APU needed:
APU RUN light illuminated - Verify
External power available:
EXT PWR AVAIL light illuminated - Verify
EXT PWR switch - Push (verify ON light is illuminated) - LT Fuel control switches - CUTOFF (verify SPAR VALVE light ON/OFF)
- Fuel Flow Indication is 0.0 - Verify
- L and R Engine Shutdown (Advisory Message present on EICAS) - Verify
- Beacon - Off, Cleared to Open the Door
———————————————————————————————————— - Hydraulic panel - Set
- Center AIR DEMAND switch - OFF
- LT ELEC DEMAND switch - OFF
- Center 1 and 2 ELEC PRIMARY switch - OFF
- RT ELEC DEMAND switch - OFF
- *Emergency exit lights - OFF
- Fuel pumps - Off
- *Window heat - Off
- *CRM PWR switch - Off
- *Cargo heat - Off
- Packs - OFF
- Isolation switches - On
- Flight directors (both) - OFF
- Status messages - Check
- *EFVS - Off
- *HUD combiner - Stowed
- *Foot and shoulder heaters - OFF
- EFB close flight - Select (x out off all screens)
- *EFB - Shutdown
- IRS - OFF
- BUS TIE switches - ISLN (15 Sec), BUS TIE switches - AUTO
- Debrief
- Do not accomplish on thru-flights
Shutdown - Trough Flight (Item DON’T accomplish) (CA)
- *Emergency exit lights - OFF
- *Windowheat - Off
- *CRM PWR switch - Off
- *Cargo heat - Off
- *EFVS - Off
- *HUD combiner - Stowed
- *Foot and shoulder heaters - OFF
- *EFB - Shutdown
After Start (FO)
- APU- As required
- Engine anti-ice - As required
- Pack selectors - AUTO
- Isolation switches - Off
- Flaps - Set
- Trim- Set
- Recall - Check
Before T/O (FO)
- EICAS status page - Select
2. Aileron and elevator - Check
After Landing (FO)
- Lights - Set
- WXR/TERR - Deselect
- Autobrakes - OFF
- Flaps - UP
- Stab trim- 2 units
- APU- As required