TB 131 - Holmatro Self-Contained Rescue Tool Flashcards
BCT 3120 Combi-Tool.
The on/off switch is of the push button type which when pressed and released will turn the unit on.
Depressing and holding the button down for _____ seconds will turn the tool off.
three
Holmatro BCT 3120 Specs
Maximum spreading travel?
10½ inches
Holmatro BCT 3120 Specs:
Maximum spreading force (back of tips)?
Max along arm?
-11,690 lbs. (tips)
-35,970 lbs. (arm)
Holmatro BCT 3120 Specs:
Allowable operating pressure 10,500 psi.
Maximum cutting force (in notch)?
49,000 lbs.
If during the operation of the tool the control handle is not turned for three seconds, the motor will slow to “idle” speed and conserve battery power.
After _____ seconds of non use the unit will shut off.
30 seconds
When finished with the tool, close the spreader/cutter arms leaving _____ inch between the tips.
¼”
The batteries have a 400 – 500 cycle life and should last over _____ years if stored and charged properly.
two years
(The best method for keeping the batteries charged is to leave them on the charger with an uninterrupted power supply.)
Tool Maintenance:
Weekly and After each use –
1. Turn unit on and operate control handle to open and close tool _____ times.
- Check pivot bolt nut by hand to ensure tightness. A loose nut should be retightened to _____ ft. lbs. of torque.
- Two times
- 75 lbs
Tool Maintenance:
Daily checks?
-Make sure the battery is snapped into place on the tool
-replacement battery is in the charger
-turn unit on to ensure battery has a charge.
Troubleshooting
What is the cause if the GREEN lights flash on the tool?
Battery power is low
Troubleshooting
What is the cause if the RED lights flash?
The max outside temp or the max motor temp has been reached
(Allow tool to cool)
Safety Precautions:
-This tool is NOT designed for lifting or raising loads.
-Do not use the tool in an environment where there is potential for explosion due to the presence of flammable or combustible gases. (Not intrinsically safe)
