Emergency Procedures Flashcards
Drivers shall not stop on any…..
….bridges which are not completely decked and provided with footwalks on both sides.
The train must be stopped short of the…
bridge if it cannot cross before coming to a stand.
Describe the difference between a position of safety and a place of safety?
- The position of safety is the initial place passengers will gather during the evacuation process.
- Once evacuation is complete and everyone has assembled in the position of safety, the train crew can then move everyone to a place of safety which will be outside the rail corridor.
Describe the time-based decision process in the Duty Card 10.1 in the TARPs document? This time-based decision process could be required if your EMU is disabled with failed air-conditioning.
- 0.30 minutes - Decision Point - will power be recovered within 60 minutes from the time of the loss? If not, begin planning for evacuation.
- 30-60 minutes - Planning - Plans should be completed with the crew and TC briefed on the actions to be taken.
- 60-90 minutes - Action - Manage safe evacuation.
- 90 minutes - Emergency ventilation stops.
In the event of a serious event or incident, who must the driver contact immediately?
Train Control
The first and most important duty of all rail personnel is?
To provide for the safety of rail personnel and the public.
State the horn signal for a fire on or adjacent to the rail corridor?
6 short
When stopped inside a tunnel with no overhead power, which train mode would you select on the TMS to enable the train to coast out of the tunnel?
Coupling mode
Mandatory relief is to be provided for excessive speed restrictions, name three further reasons mandatory relief will also be provided?
- Level crossing accident
- Trespasser collisions
- Incidences of fatigue/illness
What is the only type of fire extinguisher to be used on board an EMU train?
Dry powder
Regarding suspicious packages found on the network, what does the acronym HOT stand for?
H idden
O bvious
T ypical
When level crossing protection equipment has failed, what is the maximum speed you can travel through that crossing?
10kph
What is the major safety consideration when evacuation is required from a derailed EMU?
To ensure overhead line power has been isolated.
Name 5 platforms you must not take any item deemed to be HOT into?
Choose any five:
* New Lynn
* Manukau
* Puhinui
* Britomart
* Otahuhu
* Kingsland
* Panmure
* Newmarket
What is the minimum approach distance for person and tools to the overhead line equipment?
2 metres