73 Is this a good test?

Question 1

MACH AIRSPEED WARNING TEST

Answer 1

Verify clacker sounds

Question 2

STALL WARNING TEST

Answer 2

Hold the button until control column shaker activates.

Question 3

GROUND PROXIMITY SYS TEST switch (800)

Answer 3

• BELOW G/S and GPWS INOP lights illuminate
• TERR FAIL and TERR TEST display on nav displays
• PULL UP & WINDSHEAR alerts illuminate
• Terrain test pattern displays on nav displays
• “Glideslope”, “Pull up” & “Windshear, wind…” sound
• “Terrain, terrain, pull up” sounds & TERRAIN caution on nav displays
• “Obstacle, obstacle, pull up” sounds
• (If installed) “Airspeed low, airspeed…” sounds

Question 4

Engine/APU Fire Protection System Check TEST switch … Hold in FAULT/INOP (Indication of a good test)

Answer 4

All illuminate:

• MASTER CAUTION lights
• OVHT/DET annunciator
• FAULT light
• APU DETECTOR INOP light

Question 5

Engine/APU Fire Protection System Check
TEST switch … Hold in FAULT/INOP
(Indication of a bad test)

Answer 5

If the FAULT light fails to illuminate, the fault monitoring system is inoperative.

Question 6

Engine/APU Fire Protection System Check
TEST switch … Hold in OVHT/FIRE
(First part of the test)

Answer 6

• Bell sounds
• FIRE WARN lights
• MASTER CAUTION lights
• OVHT/DET annunciator

Question 7

Engine/APU Fire Protection System Check
TEST switch … Hold in OVHT/FIRE
(after pushing the Master FIRE WARN light)

Answer 7

• Both FIRE WARN light & bell cancel
• Red ENG 1, APU & ENG 2 fire warning switches
• ENG 1 & ENG 2 start levers
• Amber ENG 1 OVERHEAT & ENG 2 OVERHEAT
• Red WHEEL WELL

Question 8

Engine/APU Fire Protection System Check
TEST switch … Hold in OVHT/FIRE
(Indication of a bad test)

Answer 8

If the FAULT light illuminates during the OVHT/FIRE test, there is a fault on the A or B loop on one or both engines. To determine which loop is good, you must perform a follow on procedure.

Question 9

Cargo Fire Protection System Check
TEST switch … Push
(First part of test)

Answer 9

• Bell sounds

* FIRE WARN lights

Question 10

Cargo Fire Protection System Check
TEST switch … Push
(after pushing the Master FIRE WARN light)

Answer 10

• Both FIRE WARN light & bell cancel
• Both small round green EXT lights
• Red FWD & AFT lights
• Amber DISCH light
• Amber DETECTOR FAULT light is OFF

Question 11

Cargo Fire Protection System Check
TEST switch … Push
(Indication of a bad test)

Answer 11

If a red FWD or AFT warning light does not illuminate and the DETECTOR FAULT light illuminates, a detection loop is inoperative.

Question 12

What are the engine indications after a good start on a standard day at sea level (800/900/9ER)?

Answer 12

• N1: 19.4%
• N2: 58.8%
• EGT: 410 deg C
• Fuel flow: 600 lbs/hr

Question 13

What are the engine indications after a good start on a standard day at sea level (Max)?

Answer 13

• N1: 20.1%
• N2: 70.3%
• EGT: 610 deg C
• Fuel flow: 600 lbs/hr

Question 14

When should you accomplish the Engine Start - Aborted Start checklist?

Answer 14

Any of the following:

• N1 or N2 does not increase or increases very slowly after the EGT increases.
• The is no oil pressure indication by the time the engine is stable at idle.
• The EGT does not increase by 15 seconds after the engine start lever is moved to IDLE.
• EGT rapidly approaches or exceeds the start limit.