Oxygen, Pneumatic, APU, Doors, Powerplant

Question 1

At what cabin altitude do the oxygen masks
deploy in the auto mode?

Answer 1

14,000 Feet

Question 2

If only the number 1 engine was running, how
could you get bleed air to Pack 2?

Answer 2

Select X-Bleed to Open
Or
Start APU and select APU Bleed

Question 3

What does a FAULT light in the APU BLEED pb
represent?

Answer 3

APU Bleed Leak

Question 4

What does the ON light
represent in the START pb?

Answer 4

APU Starter Energized

Question 5

What does the AVAIL
light represent in the
START pb?

Answer 5

APU Start Sequence Complete
And
APU is available for use
(N1 >99.5% or 2 seconds after reaching 95%)

Question 6

If your APU
experiences an
auto shut down,
what light will
illuminate on the
overhead panel?

Answer 6

Amber APU Fault Light

Question 7

What does a FAULT light represent next to the
Cockpit Door switch?

Answer 7

Cockpit Door System Failure
Identified
(ex: Latch, Pressure Sensor, or Control Unit)

Question 8

What is the status of the Overwing Exit Doors
and Slides?

Answer 8

Over wing Exit Doors are
Locked
Slides Armed

Question 9

With the ENG MODE SEL Switch in NORM, when
is Continuous Ignition active?
(Hint: F-E-E-T)

Answer 9

1. Flaps greater than 0o in flight.
2. Engine Anti-Ice On
3. Engine surge or stall in flight
4. Thrust set to TOGA or FLEX.

Question 10

Thrust control reverts to N1 Rated Mode when
the N1 MODE pushbuttons are selected ON.
How is the Autothrust system affected?

Answer 10

!196
Auto Thrust
and
Alpha Floor Protection
are
Lost

Question 11

What is represented by the FAULT light on the
ENG panel?
(Hint: S-A-D)

Answer 11

1. Start valve Fault
2. Automatic start abort
3. Disagreement between actual and commanded
   position of HP Fuel valve

Question 12

411
What does the A/THR annunciation LVR ASYM mean?

Answer 12

Appears amber if, with A/THR active, both engines running, one thrust lever is out of the CLB detent

Question 13

413
With the ENG MODE SEL switch in NORM (with the engine running), when is continuous ignition automatically selected?

Answer 13


Takeoff power is set (TOGA or Flx)

EngAnti-Ice is on

Engine surge or stall in flight

Flap handle out of zero in flight

Question 14

415
What does the flashing LVR CLB indication mean?

Answer 14

Thrust levers are not in CLB detent, both engines running, above the thrust reduction altitude

Question 15

417
What does the flashing LVR MCTindication mean?

Answer 15

Power is not set to MCT, after engine failure, above green dot, clean config. (Note that TL’s MAY BE in the FLX/MCT detent).

Question 16

The flashing LVR MCTindication occurs after an
engine failure, once the a/c speed is above green dot.
How can you extinguish this indication?

Answer 16

Move thrust levers out of the FLX/MCT detent (CLB detent recommended) and then back to the FLX/MCT detent