Indicating/Recording Flashcards
From SPV slides April 2019
421
A valid cockpit voice recorder test will occur if what conditions are met when the CVR TEST PB is pressed?
Pressed and held: Activates the test if the CVR is energized and the parking brake is ON. A low frequency signal sounds through the two flight deck speakers.
423
What does the dashed green energy arc indicate?
The dashed green arc symbol indicates the required distance to land from present position
425
The dashed green energy arc indicates the required distance to land from present position.
When will it appear?
Only displayed in descent and approach phase when a selected lateral mode is engaged (HDG or TRK)
What is the difference between the yellow Slideslipindicator, and the Blue Beta Target?
Turns BLUE in case of engine failure during takeoff or go around
[YELLOW] Indicates Slideslip(Lateral acceleration of the aircraft)
[BLUE] When centered, indicates the optimum amount of slideslipfor best single engine performance
429
When will the BETA target index replace the turn and slip indicator?
In case of engine failure during takeoff or go-around, the sideslip index changes from yellow to blue, and its function changes to beta target
In case of an engine failure, the BETA target index will replace the turn and slip indicator. Why is it ideal to center the BETA target index?
When the beta target index is centered, the amount of sideslip is optimized for best single-engine performance (which may result in a slight bank)
433
When TO INHIBIT or LDG INHIBIT are displayed on the lower right side of the E/WD, what does this mean?
Only those failures/fires that require immediate recognition or attention are presented. Others are suppressed.
435
On approach, when is the Flight Warning Computer LDG INHIBIT feature active?
During landing (800 ftor 80 kts) phases, the right side of E/WD displays a specific LDG INHIBIT (magenta) memo, which indicates that only failures that need immediate attention are displayed by the Flight Warning Computer
437
During takeoff, when is the Flight Warning Computer
T.O. INHIBIT feature active?
During takeoff (Takeoff Power to 1500’ or 2 minutes After Liftoff)
439
What will happen if you press and hold the
ALL pushbutton on the ECAM Control Panel?
Cycles through all system pages (as long as the button is being pressed)
What occurs when you press the T/O Configpush button prior to departure?
Simulates the application of T/O power
443
What happens when you press the EMER CANC pushbutton for a WARNING?
Cancels any present aural warning as long as failure continues
Extinguishes Master Warning lights
Does not affect the ECAM message display
445
What happens when you press the EMER CANC pushbutton for a CAUTION?
Cancels any present Caution for the remainder of the flight
Calls up the STATUS page which will display the cancelled caution
Which pushbuttons remain operative in the event of an ECAM control panel failure?
Failure of the ECAM control panel, the CLR, RCL, STS, EMER CANC and ALL pbsremain operative
449
What occurs when you push the RCL pushbutton?
Calls up warning or caution messages and STS page that may have been inhibited or cleared
451
What is represented by the white SYS ON
light?
An automatic or manual signal to open the oxygen mask doors has been triggered (Auto = 14,000 cabin altitude)
453
What occurs when the guarded MASK MAN ON pushbutton is pressed?
The mask doors are manually signaled to open
455
What triggers the signal to be sent for deployment of passenger oxygen masks, when the MASK MAN ON pushbutton is guarded in auto?
The mask doors are signaled to open automatically when the cabin altitude exceeds 14,000’
457
When the Crew Supply pushbutton OFF light is illuminated, what secondary indication will be displayed and where will it be present?
Valve is closed accompanied by an amber OXY indication on ECAM Door page
After replacing the O2mask, why is it necessary to press the TEST/RESET button?
Cuts off O2 flow to the mask andcuts off the oxygen mask microphone
