NAVEDTRA 14188A, NEETS Mod. 16, Ch. 1 Flashcards
Which system is used by all branches of the military to identify equipment by a system of standardized nomenclatures?
Joint Electronics Type Designation System (JETDS)
Which year was the Electronic Test Equipment Classification Board established to control the increased use of undesirable electronic test equipment (ETE) in fleet and shore activities?
1973
Which command manages general purpose electronic test equipment?
Space and Warfare Systems Command (SPAWARSYSCOM)
Which type of test equipment has the capability, without modification, to generate, modify, or measure a range of parameters of electronic functions required to test two or more equipments or systems of basically different design?
GPETE
What was specifically designed to generate, modify, or measure a range of parameters of electronic functions of a specific or peculiar nature required to test a single system or equipment?
SPETE
What has the responsibility for evaluating requests to purchase nonstandard GPETE and for recommending its approval or disapproval to NAVSEA?
NESEA
Which program was designed to keep track of all installed and portable equipment in the fleet?
(MSCLSIS)
Which two basic elements does the SCLSIS program have?
Validation and Inventory updating
What is the checking, adjusting, or systematically aligning a test instrument to a known standard known as?
Calibration
Which label has black lettering on a white background that comes in two sizes and is the most commonly used label in the METCAL program?
Calibrated
Which label has red lettering on a white background and is used when you must know the actual measurement values to use the instrument?
Calibrated – Refer to report
Which labels or tags are used when some unusual or special condition in the calibration should be drawn to your attention and have black letters on a yellow background?
Special calibration
Which label has black lettering and a white background and is affixed when the calibration is performed by the user?
User calibration
Which label has green lettering and a white background and is used in the event that an individual instrument due for recalibration will not be used for some time in the future?
Inactive-calibrate before use
Which label has black letters and a red background and is attached to an instrument that fails to meet the acceptance criteria during calibration and cannot be adequately repaired?
Rejected-Refer to attached tag
Which label has black letters on a white background that is placed over readily accessible (usually exterior) adjustments to prevent tampering by the user when such tampering could affect the calibration?
Calibration-void if seal is broken
Which IMA policies purpose is to streamline the procedure and cut down delays in returning your equipment to you calibrated and ready to use?
No reject
Which data processing system was designed to provide a standardized system for the recall and scheduling of test, measurement, and diagnostic equipment (TMDE) into calibration facilities?
Measure
Who oversees the MEASURE program and establishes policy and guidelines?
Chief of Naval Operations
Which type of work is done to correct, reduce, or counteract wear, failure, and damage to equipment?
Maintenance
Which two main categories is the maintenance of electrical and electronic equipment divided into?
Preventive and Corrective
Which term refers to the initial operating conditions of the equipment on installation or after overhaul when it is operating according to design?
Baseline
To prevent damage to electrical measuring instruments, you should observe the precautions relating to three hazards: mechanical shock, exposure to magnetic fields, and what else?
Excessive current flow
Which measurement charts, usually found in equipment technical manuals, contain the normal operating voltages found in the various stages of the equipment?
Point-to-point voltage
