Honeywell Titan SCBA Flashcards

1
Q

The titan SCBA is compliant with what 3 NFPA standard?

A

NFPA 1981, 1404, 1500

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

The titan SCBA is approved for use above what temperature when using the 2820XX series facepiece?

A

-25 degrees

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

The SCBA should not be used beyond how many hours after initial exposure to chemical warfare agents to avoid possibility of agent permeation?

A

6 hours

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

When using the SCBA, use adequate skin protection when worn in gases or vapors that poison by skin absorption such as what type of gas?

A

Hydrocyanic acid gas

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

The EBSS (buddy breathing system) May only be installed on economy harness backpack when what type of cylinder is used with the SCBA?

A

Hoop-wrapped fiberglass cylinder or fully wrapped carbon cylinder

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What 3 safety precautions headings are found in the SCBA user manual?

A

Warning, caution, note

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

A warning safety precaution is used to highlight what?

A

Maintenance or operating procedures and techniques that may result in injury, illness, or death

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

A caution safety precaution highlights what?

A

Maintenance or operating procedures and techniques that may result in damage to equipment if not carefully followed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

A note safety precaution highlights what?

A

Maintenance or operating procedures and techniques or information considered important enough to emphasize

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What type of facial hair will prevent a good facepiece seal therefore you should not use the SCBA unless you are clean shaven?

A

Beards and sideburns

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

The SCBA is designed for storage in temperatures from what range?

A

-25 to 160 degrees

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

If the SCBA is stored below what temperature, it must be warmed up to or above this degree to prevent damage to equipment?

A

0 degrees

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

The SCBA is NFPA compliant, it is also compliant with who else?

A

NIOSH-CBRN

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

The backpack consists of what type of lightweight material for the backplate and hip plates (swivels and hinges on backplate)?

A

Aluminum

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

The cylinder is attached by a stainless steel band with integrated adjustment mechanism and has a release hatch on which side of the backpack when looking at the cylinder with the valve pointing down?

A

Right side

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

The titan SCBA harness is made of what material?

A

Kevlar straps

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

The first stage pressure reduced lowers cylinder air pressure to what psi?

A

115 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

The relief valve on the first stage regulator activated at to protect the system when the intermediate pressure exceeds what psi?

A

200 to 225 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
19
Q

The first stage pressure reducer is connected to what type of whistle or alarm?

A

Warbling whistle or bell alarm

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
20
Q

The low pressure(1/3 or 33%) SCBA audible alarm activates at what psi range (4500 psi system)?

A

1485 to 1665 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
21
Q

The low air alarm will continue to sound until the air pressure drops below what psi?

A

200 psi

22
Q

The batteries on the SCBA must be replaced when the amber LEDs on the front and back PASS flashes every how many seconds?

A

10 seconds

23
Q

In order to properly read the HUD you must have what type of vision (vision from both eyes) which must meet the requirements set forth by the authority having jurisdiction over your operations and/or workplace?

A

Binocular vision

24
Q

The HUD display consists of 4 green LEDs representing what?

A

Full, 3/4, 1/2, and 1/3

25
Q

When the SCBA pressure decreased and drops below 50% of cylinder capacity, the 1/2 will start to flash for how many seconds before returning to being continuously lit?

A

20 seconds

26
Q

When the pressure drops to 1/3 or what percentage of cylinder capacity, the green LED turns red and begins to flash giving the user a visual low pressure alarm in addition to the audible alarm?

A

33%

27
Q

The low pressure audible alarm is located where on the back pack?

A

Upper left

28
Q

When the cylinder pressure drops to what percent, the red LED begins flashing noticeably faster and continues until air pressure drops below 200 psi?

A

10%

29
Q

An external red LED mounted on front of HUD module warns others that the user air status is at what level and will flash faster at 10% and stop when cylinder is below 200 psi?

A

1/3 (33%)

30
Q

The backpack has an amber LED light and audible beep which indicates a low battery flashing and sounding every how many seconds?

A

10 seconds

31
Q

In order for the SCBA to maintain intrinsic safe certification, what 4 types of brand batteries must be used?

A

Duracell MN1400
Duracell PC1400
Energizer E93
Energizer EN93

32
Q

When replacing the batteries, prior to reinstalling battery cap, ensure that the what is not damaged, replace as required?

A

Cap O-ring

33
Q

The low battery amber LED in the lower right of the HUD flashes once every how many seconds, replace batteries before next usage?

A

Every second

34
Q

The pressure demand second stage regulator is mounted on the facepiece by what Honeywell system?

A

Air klic

35
Q

The second stage regulator will not operate until what 2 things are activated (1 or the other)?

A

First breath on mechanism or manual override button on front of regulator pressed

36
Q

Turning the large red bypass knob in what direction on the second stage regulator provides constant air flow?

A

Counter clockwise

37
Q

What connection on the SCBA provided a mean for equalizing pressure in SCBA cylinders during a rescue?

A

RIC UAC

38
Q

Where is the RIC UAC located on the titan SCBA?

A

Adjacent to CGA handwheel on lower left side of back pack

39
Q

Where is the relief valve for the RIC UAC located and is designed to vent air to atmosphere when fill pressure exceeds cylinder service pressure to prevent over pressurization?

A

On first stage regulator

40
Q

What 3 reasons should the RIC UAC fill hose must never be used for?

A

Buddy breathing
SCBA to SCBA filling
To provide continuous air supply

41
Q

For facepiece testing, each person who will wear a CBRN certifies SCBA must pass a quantitative fit test with a minimum measured fit factor of what number?

A

500

42
Q

What 2 methods can be used for donning the SCBA?

A

Over the head and coat style

43
Q

For disinfection of the facepiece, place in warm water (120 degrees) with how many table spoons of bleach per gallon of water for 2 to 3 minutes?

A

2 tablespoons

44
Q

If facepiece has been stored below what temperature and not possible to warm up prior to use, so not exhale into facepiece until is is properly donned and the regulator is installed and activated?

A

32 degrees (freezing temp)

45
Q

What may not be engaged or activated in donor mode after donor end of service time indicator (EOSTI) has activated?

A

EBSS

46
Q

What is equipped within the PASS device that can sense external temperature?

A

ThermAlert

47
Q

What provides an alarm based on the heat and time and individual has spent in a fire environment?

A

ThermAlert

48
Q

The ThermAlert is not a what type of alarm meaning is activated when user reached any point on curve and automatically stops sounding once the user leaves the range of the curve?

A

Locking alarm

49
Q

The ThermAlert will activate at how many minutes of exposures when the temperature is 200 degrees?

A

11 minutes

50
Q

The ThermAlert will activate at how many minutes of exposures when the temperature is 250 degrees?

A

8 minutes

51
Q

The ThermAlert will activate at how many minutes of exposures when the temperature is 300 degrees?

A

6.75 minutes

52
Q

The ThermAlert will activate at how many minutes of exposures when the temperature is 350 degrees?

A

5.25 minutes