Honeywell Titan

Question 1

The respirator should not be used beyond ___after initial exposure to chemical warfare agents to avoid the pos- sibility of agent permeation.

Answer 1

6 hours

Question 2

Honeywell warrants this product to be free from defects in materials and workmanship for ___ from the date of purchase, with the exception of the compressed air cylinder

Answer 2

12 years

Question 3

the standard cylinder is warranted for ___ years

Answer 3

15

Question 4

the extended life cylinder is warranted for ___ years

Answer 4

30

Question 5

the first stage pressure reducer, which is warranted for the ___ of the product

Answer 5

life

Question 6

The electronics for the Heads-Up Display (HUD), battery pack, PASS, and pressure transducer are warranted for ___ years.

Answer 6

5

Question 7

This SCBA is designed for storage in temperatures from____. If stored below 0° F, the SCBA must be warmed to above 0° F before use.

Answer 7

-25° F to +160° F

Question 8

The backpack consists of a ____ backplate with an aluminum hip plate that both swivels and hinges on the backplate.

Answer 8

lightweight aluminum

Question 9

The air cylinder is of composite construction with an aluminum inner liner overwrapped by carbon fiber, and has a maximum working pressure of ___.

Answer 9

4500 psig

Question 10

The first stage pressure reducer lowers cylinder

air pressure to a nominal ___.

Answer 10

115 psig

Question 11

The relief valve activates to protect the system when the intermediate pressure exceeds ___

Answer 11

200 to 225 psig.

Question 12

The low pressure SCBA audible alarm activates at ___ psig (2216 psi system)

Answer 12

731 to 820

Question 13

the high pressure SCBA audible alarm activates at ___ psig (4500 psig systems).

Answer 13

1485 to 1665

Question 14

The audible alarm will continue to sound until the air pressure drops below ___.

Answer 14

200 psig

Question 15

If the low battery alert activates (amber LEDs on the front and back PASS flashing every ___) during storage, the batteries must be replaced before using the SCBA.

Answer 15

ten seconds

Question 16

The display consists of four green LEDs, representing____

Answer 16

Full, 3⁄4, 1⁄2, and 1⁄3

Question 17

When the pressure drops below 50% of cylinder capacity, the LED representing 1⁄2 cylinder capacity starts to flash, and continues to flash for a short time (____) before returning to being continuously lit.

Answer 17

approximately 20 seconds

Question 18

When the pressure drops to 1⁄3 (33%) of cylinder ca- pacity, the last green LED ____, giving the user a visual low pressure alarm in addition to the audible alarm located at the upper left of the backpack.

Answer 18

turns red and begins to flash

Question 19

on a 4500 psig SCBA, the 1/3 LED will turn red and begin to flash between ____ psig

Answer 19

1485 and 1665

Question 20

When the pressure drops to ___ of cylinder capacity, the red LED begins flashing noticeably faster and continues until air pres- sure drops below approximately 200 psig, at which time the display will turn off.

Answer 20

10%

Question 21

An ____ LED, mounted on the front of the HUD module, warns others of the user’s low air status by flashing at the same time the 1⁄3 LED is flashing inside the HUD module.

Answer 21

external red

Question 22

The external red LED flashes ___ when the pressure drops to 10% of the cylinder capacity. A red LED at the ___ of the backpack performs the same functions.

Answer 22

noticeably faster / lower right

Question 23

An audible beep will also sound every ___ to indicate a low battery condition.

Answer 23

ten seconds

Question 24

Prior to re-installing the battery cap, ensure that the cap ___ is not damaged.

Answer 24

O-ring

Question 25

The RIC UAC has a ___ which must be installed over the coupling at all times before and after filling operations.

Answer 25

dust plug

Question 26

Cylinders damaged by fire or heated to ___ must be destroyed.

Answer 26

180°F