Book 2 Unit 2 Flashcards
If a faucet drips when closed, or vibrates when opened, the trouble is usually a worn __________ at the lower end of the spindle.
A) Washer
B) Seat
C) Gland
D) Spindle
E) Stem packing
A) Washer
The standard or common trap has ________ of maintaining the seal.
A) 10 cm (4 in)
B) 5 cm (2 in)
C) 38 mm (1-1/2 in)
D) 16 mm (5/8 in)
E) 75 mm (2-15/16 in)
C) 38 mm (1-1/2 in)
Wastes fro, plumbing fixtures, such as sinks, are discharged through the fixture outlet pipe into a:
A) X-trap
B) C-trap
C) P-trap
D) S-trap
E) B-trap
C) P-trap
The purpose of a trap in a sanitary sewer piping system is to:
A) Stop hair and other solids from entering the sewer
B) Allow condensate to escape wile holding back steam
C) Stop sewer gases from escaping from the waste system through the fixture
D) Keep soap scum from getting into the septic system
E) Trap sewer in the system
C) Stop sewer gases from escaping from the waste system through the fixture
The material used for indoor sanitary drainage piping in commercial buildings is:
A) PVC plastic
B) Galvanized steel
C) ABS plastic
D) Copper
E) Cast iron
E) Cast iron
The atmospheric vacuum breaker has a moving element that should the flow stop and water pressure is lost it ____________ and break the siphon effect.
A) Closes to admit air
B) Closes to admit water
C) Opens to release pressure
D) Opens to admit water
E) Opens to admit air
E) Opens to admit air
Most plumbing regulations prohibit single pipe systems over _______ in length from a water heater.
A) 30 m (100 ft)
B) 20 m (66 ft)
C) 40 m (130 ft)
D) 10 m (33 ft)
E) 60 m (200 ft)
A) 30 m (100 ft)
Backwater valves are a form of __________ valve.
A) Check
B) Butterfly
C) Gate
D) Globe
E) Ball
A) Check
Horizontal branch piping larger than 76 mm (3 in) should be installed with a slope of not less than:
A) 5cm/m (5/8 in/ft)
B) 2 cm/m (1/4 in/ft)
C) 4 cm/m (1/2 in/ft)
D) 3 cm/m (3/8 in/ft)
E) 1cm/m (1/8 in/ft)
E) 1cm/m (1/8 in/ft)
The pressure system with pneumatic tank typically has a pump on/off control start of:
A) High water level
B) Low water level
C) High air pressure
D) Low air pressure
E) Below reserve storage level
B) Low water level
The pressure system with pneumatic tank typically has a pump on/off pressure differential of:
A) 100 kPa (14.5 psi)
B) 140 kPa (20 psi)
C) 180 kPa (26 psi)
D) 120 kPa (17.4 psi)
E) 160 kPa (23.2 psi)
B) 140 kPa (20 psi)
The pressure vacuum breaker consists of a single body containing a spring-loaded check valve and an internally loaded vacuum breaker that _________ whenever the pressure within the body approaches atmospheric pressure.
A) Closes to admit air
B) Opens to release pressure
C) Opens to admit water
D) Closes to admit water
E) Opens to admit air
E) Opens to admit air
Water may leak from the flush valve of a water closet flush tank for the following reasons except:
A) The ball could be defective
B) The flush ball might not be seating properly
C) There might be dirt on the ball or the seat
D) The flush seat might be corroded or worn
E) The lift chain could be properly adjusted
E) The lift chain could be properly adjusted
The pressure in a plumbing vent system is:
A) Neutral
B) Slightly above atmospheric
C) Vacuum
D) Slight vacuum
E) Atmospheric
E) Atmospheric
Weeping tile is usually installed to prevent an accumulation of ground water around the building foundations and to reduce _________ water pressure on the walls below ground level.
A) Hydroscopic
B) Hydronic
C) Hypostatic
D) Hydraulic
E) Hydrostatic
E) Hydrostatic