Book 2 Unit 1 Flashcards

1
Q

The __________ filter is the best filter available for the removal of fine dust, smoke, and fumes.
A) Electronic
B) Electrostatic
C) Mechanical
D) Viscous impingement
E) Dry

A

B) Electrostatic

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

The presence of air in a steam heating system is undesirable since it will:
A) Reduce the heat transfer
B) Reduce the operating pressure
C) Decrease the condensate flow
D) Increase the steam flow
E) Cause the relief valve to fail

A

A) Reduce the heat transfer

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Steam in a two-pipe, vacuum return system is supplied pressures up to:
A) 75 kPa (10psi)
B) 103 kPa (15 psi)
C) 15 kPa (2 psi)
D) 50 kPa (7 psi)
E) 200 kPa (30 psi)

A

B) 103 kPa (15 psi)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Building air infiltration should be kept to a minimum a certain amount of fresh air is required to provide ___________ within the building.
A) Cooling
B) Ventilation
C) Heating
D) Humidification
E) Dust control

A

B) Ventilation

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Thermal resistance (R) is the:
A) Thermal heat flow through a unit area of a non-uniform, composite material when a unit average temperature difference is established between the surfaces (W/m2ºC)(Btu/hr/ft2ºF)
B) Thermal heat flow, by conduction only, through a unit area of a single uniform type of material (W/mºC)(Btu/hr/ft2ºF)
C) Reciprocal of thermal conductance, it is the value of a given material’s ability to resist heat transfer or flow (m2ºC/W)(ft2ºF/Btu/hr)
D) Thermal heat flow (transmission) through unit areas of a wall, door, window, etc. for every degree temperature difference between the air/fluid inside and the air/fluid outside. (W/m2K or W/m2ºC)(Btu/hr/ft2R or Btu/hr/ft2ºF)
E) Quantity of heat flow from all mechanisms, in unit time, under the conditions prevailing at that time (Q or W)

A

C) Reciprocal of thermal conductance, it is the value of a given material’s ability to resist heat transfer or flow (m2ºC/W)(ft2ºF/Btu/hr)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

With a warm air heating system if there is insufficient heat throughout the building the trouble could be:
A) Air filters are dirty
B) The bonnet temperature is at least 65ºC (150ºF)
C) An adequate amount of air is supplied to all rooms and to provide good air distribution
D) The thermostat is accurate
E) Occupied and unoccupied areas receiving adequate heat

A

A) Air filters are dirty

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

An advantage of the forced circulation hot water heating system is:
A) The response to changes in heating load is more rapid
B) Positive circulation can not be established to all heating units
C) Increased power and maintenance
D) Noisier operation
E) Larger pipes must be used

A

A) The response to changes in heating load is more rapid

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

In the electrostatic precipitator the positively charged dust particles are attracted to the metal ________ plates.
A) Neutral
B) Collector
C) Ionizing
D) Grounded
E) Parallel

A

B) Collector

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The rooftop heating unit is basically a ____________ air heater mounted on the roof.
A) Duct
B) Lowboy
C) Horizontal
D) Vertical
E) Highboy

A

C) Horizontal

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

One of the ways that heat is transmitted is by:
A) Conservation
B) Convection
C) Insulation
D) Construction
E) Occupation

A

B) Convection

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Which of the following should not be included in the routine operation of a hot water heating system?
A) Keeping the boiler room and boiler clean and tidy
B) Test the controls on regular basis
C) Keep covers on all controls
D) Make sure that the air supply to the boiler room is closed
E) Test the safety relief valve on a regular basis

A

D) Make sure that the or supply to the boiler room is closed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

The purpose of the heat exchanger in a forced warm-air furnace is to exchange.
A) Combustion gas heat with air
B) Hot water heat with air
C) Steam heat with air
D) Air heat with combustion gases
E) Air heat with air

A

A) Combustion gas heat with air

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

The piping and heating units of a steam heating system must be so arranged that:
A) Steam can flow in sufficient quantities to all heating units
B) The condensate can flow freely from the boiler
C) The condensate can be returned freely to these units
D) The air can be contained in the heating units piping
E) Steam can flow freely from all heating units

A

A) Steam can flow in sufficient quantities to all heating units

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

If there is restricted air flow through a heating unit the operator should check all but:
A) Air passages are not restricted
B) Damper plates are fully closed
C) A carpet is not restricting the air flow
D) Curtains are restricting the air flow
E) The filter is not plugged

A

B) Damper plate are fully closed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Calculate the relative humidity of a sample of air that at 21ºC (70ºF) holds 0.01 kg (0.022 lb) of moisture if the maximum that it can hold at this temperature is 0.015 kg (0.033 lb)
A) 25.8%
B) 0.33%
C) 93.3%
D) 10.7%
E) 66.7%

A

E) 66.7%

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

One of the methods of estimating the quantity of air entering a building by means of infiltration is the ________method.
A) Convection
B) Infiltration
C) Occupation
D) Radiation
E) Crack

A

E) Crack

17
Q

In a _________ system, the mains are located above the heating units.
A) Steam supply
B) Downfeed
C) Heating supply
D) Upfeed
E) Under floor

A

B) Downfeed

18
Q

The sensing element of the _________ is liquid filled and the switch is actuated by the expansion and contraction of the liquid when there is a temperature change of the controlled medium.
A) Immersion thermostat or Aquastat
B) Remote bulb thermostat
C) Bimetal thermostat
D) Humidistat
E) Pressurestat

A

A) Immersion thermostat or Aquastat

19
Q

Thermal transmittance or U-factor (U) is the:
A) Quantity of heat flow from all mechanisms, in unit time, under the conditions prevailing at that time (Q or W)
B) Thermal heat flow, by conduction only, through a unit area of a single uniform type of material (W/mºC)(Btu/hr/ft2ºF)
C) Reciprocal of thermal conductance, it is the value of a given material’s ability to resist heat transfer or flow (m2ºC/W)(ft2ºF/Btu/hr)
D) Thermal heat flow through a unit area of a non-uniform, composite material when a unit average temperature difference is established between the surfaces (W/m2ºC)(Btu/hr/ft2ºF)
E) Thermal heat flow (transmission) through unit areas of a wall, door, window,etc for every degree temperature difference between the air/fluid inside the air/fluid outside (W/m2K or W/m2ºC)(Btu/hr/ft2R or Btu/hr/ft2ºF)

A

E) Thermal heat flow (transmission) through unit areas of a wall, door, window,etc for every degree temperature difference between the air/fluid inside and the air/fluid outside (W/m2K or W/m2ºC)(Btu/hr/ft2R or Btu/hr/ft2ºF)

20
Q

The best filters available for ventilation system lint removal are:
A) Air washer
B) Dry
C) Viscous impingement
D) Activated alumina chemisorbant
E) Charged-media electronic

A

B) Dry