Avionics Failures Flashcards

1
Q

During all electronic display failures, what should you do?

A

Confirm indications in both cockpits, reference alternate data sources, reference the standby instruments, and check applicable circuit breakers

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

If you experience a loss of electronic display without a GEN BUS or BAT BUS annunciator, what should you do?

A
  1. Push the Composite switch on unaffected display

2. Check the FWD/AFT AVI circuit breaker, reset if open

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What are the indications of an AHRS failure?

A

ATTITUDE FAIL and an X over the rate-of-turn scale on the EADI

HDG on the EHSI

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

How long must there be power disprution to the AHRS circuit breaker before resetting it after it is pulled?

A

0.5 seconds

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

When accomplishing an inflight AHRS alignment, how long must the aircraft be in straight and level flight for?

A

30 seconds

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

If ATTITUDE FAIL and HDG remain on the EADI and EHSI screen, do the VOR and GPS needles provide accurate bearing information?

A

Yes, however they are slaved to the frozen EHSI compass card

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Will the DME block and CDI scale at the bottom of the EHSI function normally if the AHRS has failed?

A

Yes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

During an electrical failure that results in a loss of power to the front EADI or rear EHSI, what happens to the corresponding EFIS control panel?

A

They are also inoperative

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Should you reset an EADI or EHSI circuit breaker if you have the pull them due to an electrical failure?

A

No

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

If the EADI circuit breaker is popped, what happens to the GPS map if it is set to HDG up?

A

There will be no map, you must select Track Up for the GPS to display a map

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

If the ADC has failed, what should you expect to see after landing?

A

PMU STATUS and a FDR light

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What will be inoperative aside from the primary ADS displays when the ADC has failed?

A

TAD, Mode C, aural gear warning

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

How can you tell if the ADC has failed?

A

If a boxed ADC FAIL remains displayed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What does illumination of both the amber VSI and amber TCAS on the TA/VSI mean?

A

Total loss of the ADC

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Should the PMU remain online with a total EDM failure?

A

Yes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

If the RMU blanks during flight and returns with OFF conditions displayed, what should you do?

A

Press and hold the page button for 3-5 seconds

17
Q

Will the transponder still be function if the RMU has failed?

A

Yes, it will be and will still be sending ADS-B information

18
Q

What are you unable to hear when the audio switch is on ALTN

A

VHF comm or ICS comm

19
Q

If the AOA computer fails, does the stick shaker and aural tones for the CWS and landing gear (tones) work?

A

No