USN Dive Man Ch 7 SCUBA Flashcards

1
Q

Minimum Equipment for SCUBA?

A

1) Open-Circuit SCUBA w/ Sub press gauge.
2) BC / Life preserver
3) Weights (if req)
4) Knife
5) Mask
6) Fins
7) Watch
8) Depth Gauge

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What is the max current Knots? If exceeded, what is needed?

A

1 knot max
If greater than one knot, ORM analysis req, must be tended or have a witness float.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Advantages of SCUBA?

A

1) Rapid Deployment
2) Portability
3) Min support Req
4) Excellent horizontal and vertical mobility
5) Minimum bottom disturbances

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Disadvantage’s of SCUBA?

A

1) Limited endurance
2) Limited physical protection
3) Influenced by current
4) Lack of voice comms (unless using through water)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What is the OSHA requirements for civilian divers in SCUBA?

A

1) Max 130fsw
2) LVL 1 Chamber required for dives deeper than 100fsw or when diving outside No-D limits
3) J-valve or independent gas source with separate regulator.
4) Submersible pressure gauge
5) Must remain at chamber for 1 hr after surfacing a dive that requires a lvl 1 chamber.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is the single greatest safety practice in SCUBA?

A

Use of the buddy system.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

How often are tenders suppose to signal the divers with a line pull to ensure they’re okay?

A

Every 2-3 mins

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What piece of minimum equipment may be waived based on the CO’s discretion?

A

Octopus

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What parts of minimum equipment are not required for the pool phase of SCUBA training?

A

1) Knife
2) Press Gauge
3) Watch
4) Depth Gauge

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the typical marking on a SCUBA cylinder?

A

1) DOT material specs
2) Service working pressure
3) Serial number assigned by Manufacturer
4) Inspectors stamp
5) Month and year of initial qualification test.
6) + marking indicates air allowable 10% over service pressure.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Buoyancy compensators shall have what?

A
  • Provide a minimum of 10 pounds of positive buoyancy at the maximum depth.
  • Have jettisonable weights if integrated into the vest. n Have a power inflator.
    *Have an alternate source of inflation (oral).
  • Have an over-pressure relief valve.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What lifelines are used in SCUBA?

A

Tending line
Float Line- 11” minimum, brightly colored.
Buddy Line- Provide 6-10ft of separation between divers.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What shall SCUBA charging lines be fabricated from?

A

SCUBA charging lines shall be fabricated using SAE 100R7 hose for 3,000 psi.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What is the required emergency equipment needed to conduce SCUBA diving op’s?

A

1) Means of extraction
2) Recall Device
3) Lost Diver Kit
4) First Aid kit (crash bag)
5) Portable O2
6) Emergency Comms
7) AED
8) Bag valve mask
9) Stretcher/Backboard

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q
A
How well did you know this?
1
Not at all
2
3
4
5
Perfectly