Memory Flashcards
List the Major Zones 100 - 800?
100- Fuselage lower section
200 - Fuselage top section
300 - Stabilisers
400 - Nacelles
500 - Left wing
600 - right wing
700 - landing gear
800 - Doors
Heating the cockpit windshield is necessary because:
- It increases the flexibility of the windshields (birds)
- It keeps the windows free of ice
- It keeps the windows from fogging over
There is a heating element in the cockpit windshields.
Where abouts is it located and what heating elements is it made from?
located: between outside window and the plastic layer
made from: Gold, tin oxide or indium oxide
Table consisting of:
Tab / Movement relative to control surface / Linkage / Discription
Trim
Balance
Servo
Anti-balance/servo
Spring
List under following headings Electrolyte, cell voltage and how to measure its charge
Lead-Acid
Nickel-Cadmium
What type of metal is galvanising used to protect from corrosion?
Some steel parts such as firewalls are galvanised by coating them with zinc
The purpose of slats may be as much to _____ _____ at low speeds by curing any tendencies towards ____ ____ ____ as it is to augment the lift coefficient
improve control
wing tip stalling
Powerplants together with their pylons are often divided into zones by ___ _____, usually made of ….
Fireproof bulkheads
Titanium
Stainless Steel
Thermoplastics
A ____ ____ ____ is used to start pressurisation after lift-off and fully open the valves after landing.
Ground Relay Input
In the case of automatic fueling, the process can be controlled by ______
Micro-processors
As per CS-25, the Flow through the cabin while flying should be _______ Per Occupant
The cabin should be ketp to a temperature of ___ ^ and to a cabin pressure of ____ psi
1.2 Ib/min
25 degrees (21 - 27)
10.91 psi (8,000ft) cabin pressure
What is the main difference between an AC and a DC generator?
A DC generator contains split-ring commutators at the ends of the coil
