Chartlet #7 Flashcards
Latitude 33°43’N
60mm from the bottom of the LB Breakwater.
Latitude 33°42’N
48.5mm from southern edge of chart.
Longitude 118°12’W
103mm due W of E end of Middle Breakwater.
Longitude 118°11’W
25mm due E of E end of Middle Breakwater.
Longitude 118°10’W
120mm due W of the end of the chart.
Middle Breakwater Corner - Reference Point
MBC: From TOP of Middle Breakwater’s Corner, 9mm E, then Due S for 47mm.
Middle Breakwater East - Reference Points
・MBE #1: 7mm due N of the hump for LB Light.
・MBE #2: 238° at 8mm.
・MBE #3: Start at 118° for 24mm from E end of Middle Breakwater.
・MBE #4: Start at 196° for 48mm from E end of Middle Breakwater.
Long Beach Breakwater - Reference Points
・LBB #1 Reference Point: 332° at 29mm.
・LBB #2 Reference Point: 7mm due W of the end of LB Breakwater.
・LBB #3 Reference Point: 147° for 56mm.
・LBB #4 Reference Point: 046° for 13mm.
LB Breakwater Entrance Lines
・Territorial Sea: Directly between M and LB Breakwaters. Solid gray line.
・Colregs Demarcation Line: Directly between M and LB Breakwaters. Dashed magenta line.
・Regulated Navigation Area Line:Directly between M and LB Breakwaters. Thick Dashed magenta line.
LB Entrance Range Line
・Runs from ranges at 175°.
・Dashed until Territorial Sea Line.
・Crosses Territorial Sea Line 22.5mm from either Breakwater.
LB W Channel Lines
・From MBE #1 lines goes to MBE #2.
・Line runs at 175° (parallel to the range line) to the end of the chart.
LB E Channel Lines
・From LBB #1 lines goes to LBB #2.
・Line runs at 175° (parallel to the range line) to the end of the chart.
LB Breakwater Cable Area
・Goes 12mm due N of hump for LB Light.
・Crosses exactly to the E.
・Meets with line 12mm due N of 1mm from end of LB Breakwater.
・Goes 12mm due S of 1mm from end of LB Breakwater.
・Crosses exactly to the W.
・Meets with line 12mm due S of 1mm from E end of Middle Breakwater.
LB Pilot Area
・Start at E end of Middle Breakwater. 195.2° until chart edge.
・Start 4mm from W end of LB Breakwater. ・165.5° until chart edge.
・Connect the two above points: the line is right in middle of two Breakwaters.
・Inner Line 2.5mm thick
Ferries
・From MBE #3, 223° to the end of the chart.
・From MBE #3, 197° to the end of the chart.
G Anchorage Outline
・From MBE #4, Line runs directly at NE corner of E edge of Middle Breakwater. It is parallel to the LB Pilot Area line. Runs for 151mm.
・Next line runs at 249° until the end of the chart.
・From MBE #4, Runs due W until Middle Breakwater Corner Reference Point.
Current Sensor & Cable
・Runs from Middle Breakwater, starting between LB Light and tip of Breakwater.
・Runs slightly steeper than LB Pilot Area Line. Ends after 59mm on outer edge of LB Pilot Area Line. Ends 3mm from 33°43’N. “#”
F Anchorage Outline
・From LBB #3, points directly at NW corner of W end of LB Breakwater (148). Runs until end of chart.
・From LBB #3, goes due east until the end of the chart.
Explosives Anchorage Radius
・Center is 355 at 34mm from where top of LB Breakwater reaches the end of the chart.
・Radius is 146mm.
・(For Chartlet #7: the radius touches the end of the chart at 110.5mm below the LB Breakwater).
Regulated Navigation and Security Area Lines
Both start 7mm from end of LB Breakwater and run parallel to F Anchorage outline.
1nm Marker Line
・99. Middle of LB Breakwater - Markers (x2): Two markers on the LB Breakwater 112.5mm from end of chart.
・Line goes due S until 1mm above Anchorage F Outline.
・Then turns due E and goes until the end of the chart.
D Anchorage Outline
・From LBB #4, points directly N.
・From LBB #4, goes due east until the end of the chart.