Bold Face

Question 1

Engine Fire on the Ground
Fire warning light, GC indicating fire

Answer 1

Throttle - Cut Off (P)
Fire switch - Pull (P,CP)
(test the fire circuit, monitor GC indications, visual)
Fire Extinguisher switch - Press if required (P,CP)
(start timer 30s)

Further: Get CX list out, confirm actions, 30 secs for extinguisher to take effect.
Next Event: Prepare for egress? Notify Crew, ATC.

Question 2

Abort

Answer 2

“Abort, Abort, Abort”
Throttles - IDLE (P)
Brakes - Apply (P)
Speed Brakes - 60 degrees (P)

If leaving runway consider throttles cut off

Question 3

Engine failure in flight

Answer 3

Throttle - Cut Off unless needed
Fire switch - pull if required (fire or frozen?)
Fire extinguisher- press if required

Question 4

Crash landing or ditching immediately after take off

Answer 4

Flaps - 50 degrees (P,CP)
Gear - Down unless over water (P,CP)
Throttles - cut off after touchdown (P,CP)

Committed once select F50 due to drag…
Better to commit early (1000ft) and land in better state?
Aim 3 Gp bottom of donut, monitor speed, configure in stages.

Question 5

Uncommanded rudder, yaw, roll

Answer 5

(Check no engine failure/flap asymmetry)
Rudder Power - OFF (P,CP)

Question 6

Wind shear
Fluctuating airspeed, sink rate

Answer 6

Pickle
Roll level
Pitch 15 NU or command bar WS guidance, increase up to initial buffet if no guidance and required.
Power - max
Config - maintain until clear of shear
PM - alt, roc, aoa, radalt, adi