AVIONICS

Question 1

What 6 things will disconnect the auto pilot?

Answer 1

Trim Switch, MSW button, YD button, AP button, TO/GA button, AP/YD DISC BAR.

Question 2

Where can you look up ETA while you are on the ground?

Answer 2

Perf Init page 3.

Question 3

What happens at the bottom of the AOA red band?

Answer 3

Stick shaker activates.

Question 4

What happens at the top of the AOA red band?

Answer 4

Stick pusher activates.

Question 5

The IRS’s interphase with what componenets?

Answer 5

EFIS
AFCS (autopilot)
FDR
WX Radar
IAPS
Stall Protection System
TAWS
TCAS

Question 6

What powers the #1 IRS?

Answer 6

Left Essential Bus.

Question 7

Minimum autopilot engagement altitude during departure:

Answer 7

700 feet AGL

Question 8

Minimum altitude with the autopilot engaged during a visual approach:

Answer 8

200 feet AGL

Question 9

Minimum altitude with the autopilot engaged during a non-precision approach:

Answer 9

200 feet AGL

Question 10

Minimum altitude with the autopilot engaged during a precision approach (less than 3.5 glide angle):

Answer 10

80 feet AGL.

Question 11

If you have a Radar Altimeter failure, what is the indication?

Answer 11

a RED “RA” indication on the PFD’s

Question 12

In order to get TO/TO on the flight director, what must be set?

Answer 12

V speeds

Flaps to Take-off

Question 13

Equipment required to be operational for flight in RVSM airspace.

Answer 13

Autopilot
Altitude Alerter
Altitude reporting transponder
Air Data Computers (2)
Pitot Probe Heaters (2) on the probes linked to ADC in use.

Question 14

DO NOT use the FMS above what North Latitude?

Answer 14

73 degrees North Latitude.

Question 15

DO NOT use the FMS below what South Latitude?

Answer 15

60 degrees South Latitude.

Question 16

Ensure that the FMS POS INIT MODE is in _________

Answer 16

AUTO.

** DEFAULTS PAGE 3 (FMS/IDX/DEFAULTS/page 3)

Question 17

What type of Approaches can you do with the Standby Instrument?

Answer 17

ILS/LOC

Question 18

Will the Autopilot work on Secondary STAB trim?

Answer 18

NO. the Autopilot needs to see the Primary Stab Trim to operate.

Question 19

When operating in reversionary mode due to an ADC failure, what must be checked to ensure correct information is being relayed ?

Answer 19

Switch the transponder and XFR to the operative side.

Question 20

What does the EMER switch on the Audio Control Panel do?

Answer 20

Routes the onside audio directly to the headset. RIU is bypassed.

Question 21

Positioning the NORM/EMER audio panel toggle switch to EMER accomplishes which function?

Answer 21

Audio is routed directly to the headphones, bypassing the Radio Interface Unit (RIU).

Question 22

Where does the Standby Instrument get its Localizer and Glideslope Data from?

Answer 22

VHF 1

(FCOM 2 - 11-01-52)

Question 23

What is an IAPS?

Answer 23

Integrated Avionics Processing System.

Question 24

Where is the Standby Pitot tube located?

Answer 24

Left side of the airplane. Upper probe. (Hard wired to the STBY instrument)

Question 25

On which mode will you get NAV to NAV transfer?

Answer 25

APPCH

Question 26

What 2 ground based approaches automatically tune?

Answer 26

ILS and BC

Question 27

What is the standard stationary alignment time for the IRS’s?

Answer 27

5-17 minutes It varies from 5 minutes at the Equator to 17 minutes for latitudes 78.25 degrees and beyond.

Question 28

How do you manually change the RNP value to 4.0 (i.e. entering Oceanic airspace)

Answer 28

PROGRESS PAGE 2 (IDX>PROG>NEXT)

Question 29

How don you change the APPR MODE from LPV to RNV ( LPV NOT AVAILABLE MESSAGE) ?

Answer 29

With the approach loaded, select IDX/NEXT/ARR DATA/L2 key and change from LPV to RNP.

Question 30

If ditching, is there a way to select the Mara-time emergency HF frequency for a distress call to ships?

Answer 30

YES. TUN/NEXT/select HF 1(2)/ L5 key/ select MAR