APC CPD LOG

Question 1

• How did you prepare for the damp investigation methods training delivered to others?

Answer 1

I used referenced materials from isurve, and presented using Microsoft power point.

Question 2

• What qualifies you to train others on damp investigation?

Answer 2

The material is referenced and I have experience working with damp- it was also peer reviewed by senior colleagues.

Question 3

• What were the key learnings you took from the session on PD under the BSA?

Answer 3

The role of PD – and the introduction of the Building Regulator.

Question 4

• Have you been able to implement any of those learnings into practice since the session?

Answer 4

Yes, at JLL we now have an internal procedure for implementing the PD under BSa

Question 5

• Tell me about the types of facades you know?

Answer 5

Curtain walling, brick facades, stone facades, glass, Green facades, composite panel facades, timber facades.

Question 6

• What is the difference between a PM and CA?

Answer 6

Ca focuses on the legal and contractual obligations – PM oversees entire project during design, execution and completion.
CA- cost related and contract related issues- PM all aspects
CA – manages variations, contract disputes and drafts contracts – PM project plans and schedules, Manages risks and issues, monitors progress and performance.

Question 7

• What are the basic principals of TDD ?

Answer 7

Carry out a comprehsive assessment – DUE DILIGENCE – Identify risks and areas of concern, check for compliance, document review, Life cycle analysis, cost estimation of works like asbestos etc, recommendations, scope of limitations, photographs,

Question 8

• What are the RIBA stages ?

Answer 8

Strategic Definition
Preparation and Briefing
Concept Design
Spatial Coordination
Technical Design
Manufacturing and Construction
Handover
Use

Question 9

• What is the typical causes of failure in curtain walling and glazed facades?

Answer 9

Corrosion to fixings, structural issues, water infiltrations like faulty gaskets, thermal expansion issues, dead loads and wind loads issues..
Glass failure, sealant failures.

Question 10

• Can you tell me about RAAC and what to look out for ?

Answer 10

Reinforced Autoclaved Aerated Concrete- Typically used from 1960s onwards, can cause structural issues and collapse- 600-800 w and L.

Question 11

• What do you understand about living organisms and their damage to construction products and materials ?

Answer 11

I understand about wet rot and dry rot and the causes and affects they have on buildings.

Question 12

• What are the KEY changes to the JCT suites?

Answer 12

Updated to include BSA – PD, Gender neutral language, ESG considerations, Dispute resolution – parties can now nominate their own body.

Question 13

• How did you assist your college with PPM writing?

Answer 13

I helped her understand the requirements of PPM writing and showed them how to prioritize H&S items over aesthetical items.

Question 14

• What do you know about the different types of acoustic fit outs ?

Answer 14

PART E – RESISTANCE TO PASSAGE OF SOUND.
Sound absorption, Sound diffusion, Speech privacy, acoustic door and windows. Modular fit outs.

Question 15

• What do you know about Cathodic protection ?

Answer 15

It is used to protect concrete from further deterioration, protects the rebar from future corrosion.

Question 16

• How do you work in a healthy environment?

Answer 16

Focus on taking breaks, taking walks, avoid back chat and generally be positive in the workplace.

Question 17

• Tell me about the use of protimetres?

Answer 17

Used for concrete and checks moisture levels in materials
For concrete or brickwork they are relative readings only.
2 pins that measure the electrical resistance.