Airplane General Flashcards
You see a flashing Amber OPEN light next to the COCKPIT DOOR switch (with the associated aural alarm).
What does this mean?

Someone in the cabin has started an emergency access procedure
With the EMER EXIT LT selector to ARM, when will the overhead emergency lights illuminate?
Loss of normal electrical power
With the LAND switches selected OFF, what is the status of the landing lights?

Landing lights are extended but OFF
Which lights illuminate with EMER EXIT LT selected ON?

Overhead emergency, EXIT signs, floor proximity emergency escape path marking system are illuminated.
NOTE: Internal battereies (EPSUs) are not charged in this position and may only last 10 minutes when in use
What happens to the nose wheel response to tiller input as ground speed increases?
Nose wheel deflection response to tiller input is reduced as ground speed increases
What does a FAULT light in the TERR PB mean?

- Terrain detection function failure
- Basic modes 1-5 still operational
What will occur if the TERR PB is selected OFF?
Inhibits the terrain detection function
Basic GPWS modes 1-5 still operate
What does the GPWS SYS FAULT light indicate?
Basic GPWS mode 1 to 5 malfunction
What is inhibited when the G/S MODE PB is selected OFF?
Mode 5 glideslope mode (“GLIDE SLOPE” aural) is inhibited
What will occur if you select the FLAP MODE push button OFF?
Flap mode 4 “TOO LOW FLAPS” is inhibited to avoid nuisance warnings when landing with a reduced flap setting
What occurs when the LDG FLAP 3 PB is selected ON?
Flap mode 4 “TOO LOW FLAPS” is inhibited when FLAPS CONF 3 is selected. In this case, the ECAM LDG MEMO displays “FLAPS….3” instead of “FLAPS…FULL”
AFT AVIONICS COMPARTMENT
Do we receive an ECAM notification whent he SMOKE light illuminates and aural alert annunciates?
No. System is aftermarket and has no suppression or ECAM alert
What does the RACK POWER SMOKE light and associated aural alert indicate?
SMOKE detected in the Aft Avionics Rack
If RACK POWER is selected OFF (due to a smoke scenario) Will the SMOKE inidication remain?
No, the SMOKE detector is powered by the RACK POWER button.
If an emergency access is initiated, how much time do you have to select “LOCK” in order to prevent unauthorized access to the flight deck
- Select the LOCK position within 30 seconds of the start of the emergency access procedure to deny entry
- The cockpit door is locked, and emergency access is denied for 5 minutes
Which cockpit lighting is available on battery power only?
The RH (FO) dome light is available with battery power
CAPT flood lights work as well (not in L&S)
With the EMER EXIT LT selector to ARM, when will the OVERHEAD EMERGENCY LIGHTS illuminate?
Loss of normal electrical power.
With the EMER EXIT LT selector to ARM, when will the EXIT SIGNS illuminate?
Loss of normal electrical power
Excessive cabin altitude
With NO SMOKING sign in AUTO, EXIT signs also come on with L/G down
When does the AUTO function of the STROBE
Light switch turn the strobes on?

Weight
OFF
Wheels
With the EVAC switch in the CAPT position and an alert activated from the CABIN, what indications would be present in the cockpit?
The cockpit horn sounds for 3 seconds
CAPT sw: If activated from the cabin, the signal will only be apparent in the flight deck and will only sound in the flight deck for 3 seconds
The lights in the EMER sw flash and you hear 3 long buzzers sound in the Flight Deck.
What does this indicate?
An emergency call has been made from the cabin to the flight deck.
Which button should be used to communicate with the Cabin in an emergency?
EMER CALL button
What happens when you push the MECH pb?
COCKPIT CALL illuminates in blue on the external power panel and a horn sounds in the Nose L/G bay
(Horn will sound as long as button is held)
When are the CVR and FDR energized with the RCRD GND CTL PB in AUTO (extinguished)?
- On the ground for 5 minutes after electical power is supplied to the aircraft
- On the ground, after an engine start
- Continuously in flight
What does a flashing amber CALL light indicate?
An incoming call detected by the SATCOM system
What does a flashing blue ATC MSG light indicate?
ATC message received by CPDLC
If a CPDLC message is too long to display on one screen which button is selected to view the next page of the message.
PGE +
PGE -
The radar is selected ON in WX/TURB mode.
Within how many miles ahead of your aircraft can
turbulence be shown in precipitation?
▪ What color is used to display turbulence?

40 NM (Regardless of Range) Turbulence shown in MAGENTA
If the Radar system was selected OFF and
WINDSHEAR was selected to AUTO. Windshear
is predicted ahead of your flight path. Will you
receive a Predictive Windshear alert?

YES
Predictive WSHR warning is
provided despite radar selection
Describe the required steps to tune and track a
VOR radial after selecting STBY NAV

- Select VOR pb
- Use selector knob to tune
frequency and course - Select “ROSE VOR” on ND to
fly radial.