Transition Block B - Radiology Module - Interpreting CXR & Assessment COPY Flashcards
What is the first thing you must do when checking a patients chest x ray?
You must check the patient’s name, date of birth and hospital number on the Xray
After confirming the patients name, DOB and hospital number to confirm it is the correct patients scan, what is the next thing you must do when analyzing the CXR and why?
Must check the date and time the CXR was taken as some patients have several on the PACs system (picture archiving and communications system)
Next make a technical assessment by checking the: * Side marker * Projection * Degree of inspiration * Centering (is the CXR rotated) What does this side marker show?
This side marker (the L) is either incorrectly labelled or the patient has dextrocardia
How could you check if this patient’s side marker has been wrongly labelled or if the patient has dextrocardia?
You could make the distinction between the two by palpating the patient’s apex beat
Next make a technical assessment by checking the: * Side marker * Projection * Degree of inspiration * Centering (is the CXR rotated) What type of projection do the best quality CXR use?
The best quality CXRs use a PA projection taken with the patient erect facing away from the xray source
Why are PA projections preferred?
CXRs taken PA are usually well inspired The scapulae only minimally overlap the lungs The heart size can be reliably assessed
Other CXR projections include AP, supine and lateral What is the problem with AP xrays?
AP - usually if patient is sick and unable to stand AP projections can exaggerate heart size as well as the scapulae overlapping the lungs - can simulate or mask disease
AP xrays can be carried out if the patient is sick and unable to stand However these xrays may exaggerate heart size as well as the scapulae overlapping the lungs - potential to mimic or mask disease When are supine xrays carried out?
Supine xrays can be carried out in patients who are two unwell to sit up - these xrays are also annotated by the photographer
What are the problems with supine xrays? (makes it difficult to diagnose different diseases (try name 2, both involve conditions where there is air where it shouldnt be and cant be seen properly on supine xrays)
Pneumoperitoneum (see image)- normally diagnosed using an erect CXR as gas rises to accumulate below the diaphragm - using supine CXR does not allow the gas to rise Pneumothorax - Pleural air is seen anteriorly adjacent to the heart rather than at the ape of the lung
Next make a technical assessment by checking the: * Side marker * Projection * Degree of inspiration * Centering (is the CXR rotated) How do you check if a CXR is adequately inspired?
On an adequately inspired CXR, 6 anterior rib ends should be visible above the left diaphragm
What is the importance of recognizing whether CXRs are well or poorly inspired?
Poorly inspired CXRs can exaggerate the heart size and the basal lung markings - this can simulate heart disease or lung base infection
Next make a technical assessment by checking the: * Side marker * Projection * Degree of inspiration * Centering (is the CXR rotated) After checking for a correctly labelled side marker, the projection of the CXR and the degree of inspiration - the final check is to look for centering and to see if the CXR is rotated * How do you check if the CXR is rotated?
To assess whether a CXR is well centered or rotated, you need to measure the distances from the medial ends of the clavicles to a thoracic spinous process
Is the CXR well centred if the distance between the medial ends of the clavicles to the thoracic spinous process are: * The same on both sides * Non-equal on both sides
CXR is well centred if the distances between the medial ends of the clavicles to the thoracic spinous process is equal on both sides If unequal the CXR is said to be rotated which can cause problems
Technical assessment - remember (side marker, projection, degree of inspiration, centered/rotated) It is of course difficult to obtain a perfectly centred CXR How does a little rotation affect diagnostic quality? How does a grossly rotated CXR affect diagnostic quality?
A little rotation doesn’t affect the diagnostic quality of a CXR A grossly rotated CXR can greatly affect diagnostic quality by exaggerating heart size or simulating a hilar or mediastinal mass Rotation can also cause the lun size to seem unequal leading to a misdiagnosis of lung disease
Describe the differences in the two xrays - nb both are actually normal but the rotation can lead to a misdiagnosis
Both CXRs are AP erect and well inspired The first Xray is rotated as the distance between medial ends of clavicles to thoracic spinous process is unequal - could lead to a misdiagnosis of left lower lobe pneumonia with displacement of the heart to the right
We have finished the technical assessment of the XRAY (side marker, projection, degree of inspiration, centered/rotation) NEXT we go through the pathological assessment of the XRAY EASIEST done systematically - ABCDE What do these stand for?
Airway Breathing Cardiac Diaphragm Everything else
CXR Name, DOB, Hospital Number Date and time taken Technical assessment Pathological assessment - ABCDE What are the main things examined in A?
Airway * Trachea * Carina and bronchi * Hilar structures
Airway * Trachea * Carina and bronchi * Hilar structures Where should the normal trachea be? What conditions could deviate the trachea?
The normal trachea should be central - if deviated, look for structures that could push or pull the trachea Push the trachea - this could be caused by a large pleural effusion or tension pneumothorax Pull the trachea - this could be caused by eg a lobar collapse
Airway * Trachea * Carina and bronchi * Hilar structures What level is the carina located? and what is it?
Carina is located at T5-T7 vertebrae - rib2 it is where the trachea divides into the left and right main bronchii
On a good quality CXR this division (the carina) should be visible and is an important landmark when assessing nasogastric tube placement, as the NG tube should bisect the carina if it is correctly placed (i.e. not in the airway). Why is it more common for foreign objects to be inhaled into the right lung?
This is because the right main bronchus is generally wider, shorter and more vertical than the left main bronchus - more direct route for foreign pathogens / objects
Airway * Trachea * Carina and bronchi * Hilar structures What forms the hilar shadows that are seen on the xray?
The hilar shadows are formed from multiple superimposed pulmonary arteries and veins
Where do the normal right and left hila lie in relation to one another?
The normal right hila lies 1.5cm below the left hila (this is because the right pulmonary artery is lower than the left and therefore the hila must be lower)