TB Tools 28 DS Ogura Cordless Rebar Cutter

Question 1

The max. size diameter the Ogura can cut

Answer 1

1 inch

Question 2

The Ogura’s casing has been designed to protect the internals from what

Answer 2

Moisture and Dust

Question 3

On what side can the support handle be installed (3 answers)

Answer 3

Left, Right and Top side of the cutting head

Question 4

Name the 2 speed modes of the Ogura

Answer 4

High Speed Mode and High Torque Mode

Note: The Ogura will select the operating mode automatically

Question 5

Moving the switch to this position will power on the Ogura

Answer 5

# 1 position
Note: Then push down on the forward end of the switch to lock it for operating continuously

Question 6

Position the tool so it is at ____ degrees to the rebar to be cut

Answer 6

90 degrees

Question 7

Once powered on when should cutting begin

Answer 7

When the Tipped Saw blade is at full speed

Note: Do not start cutting immediately after the motor is switched on

Question 8

Moving the switch to this position will turn off the Ogura

Answer 8

0 position

Question 9

When should members hold the material that’s being cut

Answer 9

Never

Question 10

Name an occasion when the Ogura will automatically stop during an operation

Answer 10

Tool is overloaded or overheats

Note: if the tool is repeatedly operated under these conditions, the protection system will lock the tool

Question 11

When should the Ogura be operated and checked for defects

Answer 11

Weekly

Question 12

After use and prior to storage, the tool should be cleaned by using what

Answer 12

A clean dry cloth

Note: solvents should not be used

Question 13

When should the batteries of the Ogura be checked

Answer 13

Start of each tour