MPC's Flashcards
(406 PLB) do not depress and hold the self test button for longer than ________ seconds when performing the PLB self test.
2 seconds **to prevent accidental activation, the PLB antenna SHALL be stowed during self test**
(406 PLB) PLB will sound an initial audible beep tone and flash the green LED, followed by _______ audible beep tones, and then a solid _______ LED to indicate that the self test was successful.
- 4 audible beep tones - solid green LED
(406 PLB) self test fail
- red LED illuminates indicate a failed self test –> perform 2nd self test - if 2nd test fails, remove battery and scrap
(RESCUE BASKET) consumables
- anaerobic single-compound adhesive, Loctite 242(BLUE TYPE)(ASTM-D5363) 2. torque seal, F-900 3. lubricating oil, MIL-PRF-32033 4. detergent, general purpose, MIL-D-16791
(RESCUE BASKET) load test (FOLDING LITTER)
- 600 lbs. - raise the basket clear off the deck, then lower the basket back to the deck a MINIMUM 5 times. - suspend basket 3 inches off the deck for 15 minutes.
(RS RADIO) silicone grease compound ___________.
silicone grease compound, G661
(RS RADIO) radio has a ___-month warranty period from date of manufacturer.
36-month.
(RS RADIO) how many screws are on the back-plate?
8 screws (hand-tight)
(RS RADIO) if fewer than ______ tabs are shown, recharge the battery pack.
two(2) tabs.
(RS RADIO) press and hold the H/L LOCK button for ______ second(s) until it beeps twice.
1 second
(SEAS-1) operational check
- ease of breathing by inhaling 3 to 5 times - pressure should remain in green area (2700-3000) psi
(SEAS-1) cylinder replacement
- not to exceed 120 month’s from original installation date.(10 YRS)
(FOLDING LITTER) hoisting sling compression sleeve tolerance
0.375 - 0.405 inch.
(FOLDING LITTER) hoisting sling cables
- any single strand in the cable having 2 or fewer broken wires may be trimmed as needed. (2 wires = TRIM) - any hoisting cable having 3 or more broken wires requires a hoisting sling change (3 wires = CHANGE)
(LPU-27/PE) consumables
- anaerobic single-compound adhesive, Loctite 271 2. lithium grease, dry lubricant, Miltec-1 - blow dry fittings on medium setting for 30 seconds 3. leak test compound