G-3 ICI

Question 1

1. Pre-assembling footing forms- outside corner

Answer 1

Footing ladders are pre-built while the excavation is being dug and set to one side for quick installation. Positioned over the building corners.

Question 2

2. Types of footing forms securely weighted down

Answer 2

Tapered Pier footings

Question 3

3. On a pile locate the foot

Answer 3

Check phone (go to page 5)

Question 4

4. Pile type that rely on side pressure to carry a load

Answer 4

Friction piles

Question 5

5. Case pile type “x”

Answer 5

Take pic of case piles pg.20 and review differences

Question 6

6. Components of insulated concrete forms

Answer 6

Patented insulated concrete forming systems usually consist of panels,ties,corner,anchor brackets, and metal tracks. Products and installation may vary from one manufacturer to another.

Question 7

7. Foundation walls for flat insulating or (insulateting) concrete

Answer 7

ICF Foundation walls that fall under part 9 of the BCBC do not require reinforcement.

Question 8

8. Flat insulating concrete form foundation walls required

Answer 8

Maximum floor to height is 3m (9’10).

The building is no more than two storeys in height and contains only one dwelling unit .

The building location is in seismic spectral response acceleration Sa (2.0) zone of not more then 0.4

Question 9

9. Important why are the outside corners are made stronger

Question 10

10. Erecting form panels, what is done first

Answer 10

Should be oiled or sealed before use to prevent swelling when concrete is placed.

Question 11

11. Vertical formwork material quantity calc

Answer 11

contact area?!?!?

Question 12

12. The walls forming sheathing panels joints- inside+ outside

Answer 12

edges and ties and joist must align on inside and outside for the ties

Question 13

13. Advantage of having all side of column same size

Answer 13

the forms are interchangable

Question 14

14. Gang form wall panels are lifted up and reset

Answer 14

Gang form panels have lifting rings attached to the top of the strong-backs. the crane used a spreader bar to ensure that there are no lateral forces acting on the strong backs.

Question 15

15. How to control gang forms panels when they are framed

Answer 15

Having a crane on site allows the larger forms to be built and moved from place to place

Question 16

16. Most common time of forms to be damaged

Answer 16

Stripping before the concrete has gained sufficient strength

Question 17

Order to layout 24’ o.c tie spacing on 4’x8’

Answer 17

check pg.65

Question 18

Horizontal reinforcement in flat insulating concrete wells imperial math

Answer 18

foundation horizontal reinforcement pg.33