Fams Ground School Systems #1 Flashcards

1
Q

The drive link lever and collar set causes the rotating swashplate to rotate at what speed compared to the rotor system?

A

At the same speed as the rotor system

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What will happen if the airframe filter becomes clogged?

A

The bypass valve will allow fuel to flow to the engine if the air frame filter becomes clogged

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Where is engine bleed air mixed with cabin air?

A

The heater silencer

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What controls the amount of ventilating air entering the cabin?

A

Two push/pull cable controls on either side of the center console

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What should you place the environmental control switch to if the DUCT TEMP HIGH caution light illuminates?

A

FAN

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Where does the Nf governor recieve its inputs from?

A
  • Internal flyweight
  • Linear actuator
  • Collective position
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

How is the engine oil pressure gauge powered?

A

Wet line only

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What completes the circuit from the common BUS to the igniter?

A

The generator field control relay

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What is the purpose of the induction fairing?

A

To channel air to the engine

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the purpose of the tension torsion strap?

A

To absorb centrifugal forces and allows for pitch change of blade

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What intermixes fore-and-aft and lateral cyclic inputs?

A

Mixing lever (bellcrank)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

How many engine mounting pads does the accessory gearbox have?

A

It has four mounting pads but only three are used for mounting.

The top pad is used to mount the anti-icing motor.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What is the generator power rating?

A

30 Volts/150 Amps

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What is the generator output regulated to?

A

28 Volts/105 Amps

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

The overvoltage sensing relay disconnects the generator from the circuit if the line voltage reaches what?

A

31 ± 1 volts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

The front end of the freewheeling unit inner race shaft connects to the ____ and the aft end connects to ____?

A

Front end connects to the main drive shaft

Aft end connects to the tail rotor drive shaft

17
Q

Where is the KAflex (barbell) shaft located?

A

Between the freewheeling unit and the transmission

18
Q

The SLAB battery used in the TH-57B is ____ volts and has a discharge rate of ____ ?

A

24 volts

17 Amps

19
Q

What side of the engine is the fuel control unit located on?

A

The right side

20
Q

What are the max forward/sideward/rearward airspeeds (sea level, standard day)?

A
  • 130 kts
  • 25 kts
  • 15 kts
21
Q

What is the cargo hook capacity?

22
Q

What kind of fuel control system is in the TH-57 B/C?

A

Pneumatic mechanical

23
Q

Where is the engine internal oil filter located?

A

Inside the accessory gear box near the top mounting pad

24
Q

The hydraulic fluid is cooled by the ______ and air from the ______?

A

Fanning of the power pack

Engine oil cooler blower

25
Where is the engine internal oil filter located?
Inside the accessory gear box near the top mounting pad
26
What are tail rotor blades made out of?
Aluminum honeycomb with stainless steel skin
27
Where is engine oil temperature measured?
At the oil tank
28
What is the droop compensation system directly connected to?
The Nf governor