Data Sheets - Documents, Pressures & Materials Flashcards
Weld Procedure (IX: Various)
WPS
Qualification Record of a Weld Procedure (IX: Various)
PQR
Welders Qualification Record (welder’s paper) (IX: Various)
WPQ
Document that must be prepared and maintained for each vessel and relief device (510: 5.1)
Inspection Plan
Manual that must be prepared and maintained by each Owner/User that uses API 510 (510: 4.2.1)
QA Inspection/ Repair Manual
Two documents that are needed by each Repair Organization that repairs relief devices (510: 6.6.1.1/2)
QC Manual & Training
Design pressures within scope of ASME Section VIII & API 510 (VIII: U-1.c.2.h.1 & 510: App A b.8)
> or = to 15 psig
Design pressures of non-fired boilers (waste heat boilers) that require Full RT (VIII: UW-11.a.3)
> or = to 50 psig
Minimum range of pressure gauge used during a test (VIII: UG-102.b)
1.5 X P test
Preferred range of pressure gauge used during a test (VIII: UG-102.b)
2.0 X P test
Maximum range of pressure gauge used during a test (VIII: UG-102.b)
4.0 X P test
Material subject to temper-embrittlement (510: 3.59)
Low Chromes
Materials subject to chloride stress-corrosion cracking (571: 4.5.1.1)
300 Stainless Steel
Material subject to polytheonic acid stress-corrosion cracking (572: 9.4.1)
300 Stainless Steel
Common material with an endurance limit (fatigue cracking cannot occur below this stress level (571: 4.2.16.3.b.i)
Carbon Steel
