ASW Flashcards
Minimum px to jettison full sonobuoy launcher
1100 psi
If sonobuoy launcher px less than 1100 psi
last buoys in sequence may not jettison
System secures at __ psi to ensure safe separation of launched buoys
250 psi
Carry up to __ buoys (__ with LHEP)
25; 15
Carry up to __ lbs of buoys
800
Sonolauncher is connected to which PIU?
LIB
Sonolauncher servicing
1175 +/- 25 psi
can you launch a buoy with transducer in the water?
No
DICASS Shallow Family
50, 150, 300 ft
DICASS Deep Family
90, 400, 1500 ft
DICASS stands for
Directional Command Activated Sonobuoy System
DICASS preset channels
A, B, C, D
DIFAR stands for
Directional Frequency Analysis and Recording
AN/SSQ-53F/G
DIFAR
AN/SSQ-36B
BT buoy
AN/SSQ-62E/F
DICASS
DIFAR depths
90, 200, 400, 1000
Cable angle sensors measure
angular displacement of cable from center of funnel relative to a/c orientation
What does RMIU do?
compensates longitudinal and lateral displacements for reeling machine installation and pitch of funnel, then provides them to AFCS and mission systems
Each time dome lowering/raising is stopped/started in water, cable angle signals are decoupled from AFCS by RMIU for __ seconds to __
9; prevent erratic helo movement due to waves set in motion along transducer cable as dome starts/stops
Outer and inner rings on cable angle
8.5 deg; 4.25 deg
CABLE ANGLE AT LIMIT
7.5 deg
scale on tick marks
2 deg per tick
Warning for outer ring being exceeded while dome is exiting the water
significantly increased risk of dome striking a/c including rotors which may lead to injury and/or death
Caution for outer ring being exceeded while dome is exiting the water
increased risk of sonar dome striking a/c which may result in equipment damage
AFCS defaults to hover mode when dome is raised through
27 +/- 12 ft
If one axis (lat/long) fails, press __; remaining axis is __
reset; fully functional
Conditions required for cable angle hover mode
+/-5 KGS, altitude hold within 10 ft of selected altitude, dome wet indication
cable angle hover mode keeps the dome perpendicular to
the water surface/horizon
with submerge override engaged, cable angle hover will ___ disengage when dome leaves water
not automatically
Mk-54 Launch Envelope Speeds & Altitude
55-110 KIAS
200-525 ft
Sonobuoy Launch Envelope
> = 70 ft
0-150 KIAS
0-30 AOB
Gate Position
Aircraft into wind, wings level, FTP on nose (0.3 nm for day, 0.5 no for night)
Day and Night approach distances
Day - 0.6 nm, 0.3 nm
Night - 1.5 nm, 0.5 nm
Engage hover mode when
Less than 5 KGS
Steady coupled hover
70 ft, less than 4 KGS
At night, turns shall not be initiated until
Stabilized flight at 150 ft
Requirements for Cable Angle Hover Mode
Ground speed of +/- 5 knots
Altitude hold within 10 ft of selected
Dome wet indication
Potentiometers should be used to adjust groundspeed to (WING SOP)
No greater than 2 KGS
Cable angle hover mode ___ be operable for all dipping sonar ops (WING SOP)
Shall
Dipping sonar ops ___ not be conducted in seas with wave heights in excess ___, winds in excess of ___, or known/discovered currents greater than ___ during unit level training or fleet level exercises (WING SOP)
Should; 10 ft, 17-21 kts, 4 kts
During dipping with or without a sub, POCL shall be no more than ___. When ceilings are above 1000 ft, POCL shall be no more than ___. During operational ASW involving a sub, under conditions that preclude a freestream recovery, then POCL ___.
Half the ceiling up to 1000 ft ceiling
500 ft below ceiling
Need not be restricted
SSBN class
ballistic missile/nuclear powered; carry nucs
SSN class
nuclear powered; attack ships
SSGN class
guided cruise missile/nuclear; attack countries
Russian diesel
kilo
SSP class
air independent propulsion (diesel)
SUBMRG light on at ___ ft when lowering and off at ___ ft when raising
28, 20
RMCU 1177
Loss of uplink
Kiting light
Condition when cable is paying out at a greater rate than TA depth is increasing
Where can you find RMCU codes?
Ch 18 of NATOPS
Normal dipper modes
Automatic and manual hydraulic modes
Auxiliary Hydraulic Mode
- manually controls Servo valve if RMIU fails
- bypasses RMIU and RMCU and all safety locks
- does not stop it at trail, lock it or seat it
- used if electrical failure
- used to correct miswraps, reseat to get a SEATED light, to recover transducer when reeling machine control system has failed
Caution about lowering the dome via aux hyd
Will damage electronics because it doesn’t have ESD
Aux Electric Mode
- full safety features
- stops at trail
- slower raise speed —> cable not sufficiently tensioned so may cause problems if raising TA from 1000 ft or deeper
- used in the event of a hydraulic fault
- can only be used to recover dome
- except in emergency, shall only be used if dome submerged
Aux Hardware Electric Mode
- bypasses all safeties - doesn’t auto stop or lock
- entered by holding RMCU SAFETY OVRD and RMCU RAISE when in aux electric
- used when failures prevent any other mode
- raise only
Hand Crank Mode
Mx only
Bottom light
Within 50 ft of bottom
Priorities for landing location with hung dome
- Ashore or aviation ship (CVN or LHA/LHD)
- Air capable ships may be considered if ambient conditions and POCL permits pilots’ adequate reference to position the aircraft
Submerge override (WING SOP)
Shall not be used for routine ops