4 - Auto Flight Flashcards

1
Q

When does FLARE engage during a dual channel approach

A

50 feet

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Before what altitude must you select the second autopilot for a dual channel approach

A

800 feet

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

When you use CWS ROLL, within how many degrees will the AP return to lever flight when you release the controls

A

6 degrees

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What does the AFS (Auto Flight System) consist of?

A

AFDS (Autopilot Flight Director System) and A/T (Auto Throttles)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

If you engage the autopilot in CMD after take-off, what is the pitch mode it engages in

A

MCP SPD

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

When will LNAV auomatically disengage

A

When reaching a route discontinuity

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What are the indications in the MCP Speed window if you select an overspeed or an underspeed

A

Underspeed: A prefix
Overspeed: 8 prefic

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What is the minimum speed for MCP selection based on

A

Angle of attack 1.3Vs,

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

How much do you have to increase the MCP Speed in order to remove the underspeed symbol

A

15 kts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Which A/T modes permit manual movement of the Thrust Levers (with no reset)

A

ARM and THR HOLD

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

When does antenna switching from tail to nose antenna happen?

A

LOC frequency selected, and VOR/LOC armed or engaged

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

When will both APs disconnect in case of FLARE not being armed on a dual channel approach?

A

350 feet RA

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

How many FCCs does the plane have (Flight Control Computers)

A

2

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What happens when you press the TO/GA switch once below 2,000 feet?
And the second time?

A

A/T advance thrust levers until the reduced G/A thrust limit, to produce around 1,000-2,000 FPM climb.
Second push gives you full G/A thrust

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

If you move the control column in pitch during ALT HLD what will happen

A

It will go into CWS P, but will go back to the selected altitude if released within 250’

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

On lift-off, how long does the A/T stay in THR HLD

A

Until 800 feet RA

17
Q

What provides the A/T with N1 limit values

A

The FMC

18
Q

What happens if you push the SPD INTV button on the MCP during VNAV operation

A

The MCP Speed window will open with the FMC target speed

19
Q

What are the functions of the ALT INTV switch

A

Remove the next crossing restriction between you and the MCP set altitude.
Set a new cruise altitude in the FMC (only higher)