Trim Carpentry Flashcards
Maintain a minimum reveal of _______ of an inch around the perimeter of all doors, +/- ______ of an inch on the hinge side.
1/8”
1/16”
What’s the maximum play on exterior doors?
1/16”
Warping on doors is not to exceed _______ of an inch.
1/4”
Doors not to move (ghost) when opened to a ______ angle.
45˚
When do we require a sill pan flashing?
When we have an overhang less than 6’ on an exterior door.
There are to be no _________ at the header casing of wood bi-pass doors.
Shiners
The slap jamb on wood bi-pass doors are allowed to be bowed a maximum of _____ of an inch.
1/8”
Door _________ are to be installed on the back of all wood bi-pass doors.
Stoppers
From what distance do we view base?
5’
From what distance do we view casing?
3’
Bows in base are not to exceed ______ of an inch in _______ feet.
1/4” in 8’
Shelving material is to be tight to the wall with gaps not exceeding ______ of an inch.
1/8”
Replace if over 1/8”
Shelving is to be level within ______ of an inch in _______ linear feet.
1/4” in 8’
A shelving support bracket is required every _______ feet.
4’
Bullnose and exposed edges of shelving are to be __________ smooth.
Sanded
What’s the tolerance for chips, gouges, saw marks, etc., on shelving?
No tolerance
Deadbolt holes are to be drilled through the jamb until the deadbolt extends into the _________ position.
Locked
The top hinge of exterior doors (and interior solid core doors) require ________ 3” screws.
2
Deadbolt strike plates are to be flush with 3” screws in _________ holes in the plate.
All
Should there be any daylight showing at the exterior door weather stripping?
No
Fire doors should self-close when held at _____ degrees.
45˚
All door hardware screws are to be _______________ and installed _________.
Countersunk
Straight
The bottom of doors should not rub on any ______________ .
Flooring
What kind of stopper should be used at exterior portal doors?
Wall stopper
What’s the maximum play on interior doors?
Zero
