Pressurization Flashcards

1
Q

What areas are not pressurized

A

Radon’s
Landing gear bays
Air conditioning compartment
Tail section

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Pressurization is maintained by 1 of 2 pressurization controllers. Each controller controls a ________?

A

Motor that opens and closes an outflow valve.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Pressurization can be Monitored by referencing

A

The cruise and cabin press pages of the SD

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What controls the outflow valve in flight and ground?

A

An electric motor that gets info from cabin press controller.

After landing the controllers switch rolls.

During flight if active controller fails the standby takes its place.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

If both Press controllers fail in flight then the Manual backup will work by_________?

A

Selecting mode selector in Cabin Press panel.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Status of controllers is selected on

A

CAB PRESS page.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

If switched to manual how do you control outflow

A

Man v/s switch

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

How do you switch controller rolls

A

Select man on mode sel for 10sec or more.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Press controller input includes

A

FMGS
-planned cruise alt
-time to altitude
-point where descent begins
THRUST LEVER FEEDBACK
ADIRS(air data inierial ref says)
LGCIU(LG control & interface unit)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

One of the most important inputs to controller is the

A

Destination airport elevation- it receives this info when landing elevation selector is set to auto.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

To set the landing field elevation manually?

When would you do this?

A

Pull the landing elec auto button out and select elevation.

Both FMGC fail or
Airport of landing is not in data base

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Outflow valve is located

A

Right side aft fuselage
Status of valve is displayed on cab press page.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Safety valves are located

A

Aft right side above flotation line.

There is one SAFETY icon on CAB PRESS page that represents both safety valves

If indication is Amber there is a problem.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Ditching push button closes all fuselage opening below the flotation line.

A

Outflow valve
Emergency ram air
Avionics ventilation extract valve
Pack flow control valves
Aircraft with cargo heat would close

If operating manually the outflow valve we need to be closed manually.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Cabin begins to pressurize when?

A

Before rotation.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Rate of descent is limited to

A

750’

17
Q

In ground mode if there is residual pressurization in cabin then?

A

Outflow valve opens gradually until no more press and it is fully open

18
Q

Abort mode is enabled if a descent is sensed below 8000’

A

It will reset controller to departure airport elevation. This is automatic and no pilot action is required.