Plant, Tools And Access Equipment Flashcards
What must employees have to be safe in work when operating equipment?
- Information.
- Instruction.
- Training.
- Supervision.
What should you conduct visual checks on before use?
- Hand tools.
- Power tools.
- Access equipment.
Basically everything.
Can anyone use a MEWP (mobile elevated work platform)?
No you need a licence that has to be reauthorised every 6 months.
Is it safe to shoot yourself with compressed air?
No because it can cause damage under the skin.
Can you use an angle grinder in explosive environments?
No because of the sparks.
What should you think about before working in terms of your surroundings?
- If anything could slip / fall.
- If there is anything flammable / explosive.
- Any extra PPE needed for the area?
- Is there anyone nearby that is at risk?
Who can enter hazardous areas?
Only trained people.
What is the stroboscopic effect and why does it happen?
The stroboscopic effect happens when there is a fast moving object that is under certain fluorescent lights.
How can you reduce the stroboscopic effect?
- Balance light over 3 phases for less flicker.
- Install high frequency lights for no flicker.
When should barrier creams be used?
When handling toxic materials or chemicals.
What are some employers responsibilities to keep employees safe
- Provide PPE to employees.
- Provide training courses.
- Provide supervision when needed.
How long can you use ladders for?
Short jobs, no longer than 30 minutes.
What should you do when using a ladder?
- Carry out any pre use checks.
- Use the right ladder for the right job
- Understand how to erect the ladder correctly.
- Don’t use it for more than 30 minutes.
How should you carry ladders?
By resting them on your shoulder.
What should you always maintain when on a ladder?
Always maintain three points of contact.
What should you NOT do when on a ladder?
Don’t overreach and put too much weight on the ladders.
How far do you need to stay away from overhead cables when on a ladder?
At least six meters hoirizonltoly unless the cables dead.
What shouldn’t you rest ladders against?
Any weak or slippery surfaces.
What ladders shouldn’t you use for electrical work?
Conductive ladders.
Can you work from the side of a stepladder?
Always work straight on.
What is the correct angle to rest ladders?
75 degrees or 1:4 ladder rungs.
What are some ways of securing ladders?
- By tying both sides to a suitable point.
- Wedge the ladder at the bottom, footing the ladder should be a last resort.
- When securing to scaffold the ladder need to extend 1 meter or 5 rungs above the platform.
What should you check for before using step ladders?
- Clean (no grease).
- Not painted to hide any defects.
- Mechanically secure.
- All rubber feet are in place.
- The safe working load (SWL).
Who can erect scaffolding?
Anyone with a valid PASMA licence.
