Labs Flashcards
What neurotransmitter is released at the neuromuscular junction and what type of receptor does
the neurotransmitter bind to?
Acetylcholine, which binds to Nicotinic Acetylcholine Receptors
If you blocked acetylcholine receptors at the neuromuscular junction, how would normal
contraction (stimulated through nerve activity) be affected? Would a muscle being electrically
stimulated directly be affected?
Muscle contraction caused by electrically stimulating the nerve would be blocked, but if the muscle itself
was electrically stimulated directly it would contract.
What is the difference between an isometric and an isotonic contraction?
Isotonic contractions involve a change in the muscle length, maintain the same force as it changes in
length. Isometric contractions involve no change in length with changing force.
What is the difference between a concentric isotonic contraction and an eccentric isotonic
contraction?
Concentric means the muscle shortens, eccentric means the muscle lengthens – both whilst generating
force.
What pattern/frequency of stimulation produces summation?
Due to the muscle being stimulated to contract again before it’s completely
relaxed from the previous contraction. Mycoplasmic calcium concentrations oscillate above and below that “threshold” required for contraction.
What pattern/frequency of stimulation produces a tetanic contraction?
Frequency of depolarisation means that mycoplasmic calcium levels don’t dip
below that “threshold”, so the actin/myosin interaction generates tension in a continual, smooth force.
How much extra tension can be produced during a tetanic contraction as opposed to a single twitch ?
6-7 times greater
State whether the muscle has time to relax during each of the different contraction patterns.
- Single twitch: relaxes completely between stimuli
- Summation: Stimuli closer together do not allow for relaxation
- Summation leading to unfused tetanization: Stimuli are far enough to allow muscle to relax slightly between stimuli
- Summation leading to complete tetanization: Muscle reaches steady tension
What causes muscle to lose tension in tetanic contractions, given that it had a continuous stimulus ?
Fatigue (eventually)
What is the Bragg equation of diffraction ?
S = λ / sin θ Where s = sarcomere length λ = the wavelength of the laser θ = is the angle subtended by the zero and 1st order diffraction spots (measured experimentally)
When a sarcomere shortens (muscle contraction), which of the following change dimension and in what
way?
A-band I-band M-line Z-line H-zone M-line to Z-line distance Thin filament length Thick filament length
I-band (shortens)
H-zone (shortens)
M-line to Z-line distance (shortens)
At what muscle length (expressed as a % of its resting length) is maximum active tension
produced?
At 100% of its resting length
Explain what is responsible for ‘passive resting tension’ and explain the relationship between
passive tension and sarcomere/muscle length
Passive resting tension is generated from the “stretch” of the series elastic and the muscle itself due to
the length the muscle is held at – It’s the natural propensity of the muscle to recoil due to its material
properties and is not therefore a measure of tension generated by the interaction of actin/myosin.
Explain what is meant by ‘active tension’. How has it been calculated?
Active tension is the force generated by the interaction of actin and myosin in that ATP-dependent
manner – e.g. the actual generation of force due to the contraction of the sarcomere and not the recoil
caused by the material properties of the muscle. It is calculated from subtracting the passive force
from the total force generated by the muscle.
How does active tension relate to the degree of overlap of the filaments?
If too much overlap, sarcomere has no room to move because the A bands are butted right against the Z line, so it isn’t possible to shorten the sarcomere to cause tension to be generated.
If too much distance, no overlap between the actin and the myosin, so no force can be generated