Jerome Meter Flashcards
What does the Jerome Meter test/Analyze?
Mercury Vapors in the low ųg/m3 or
mg/m3
What is the measurement of when an area or person is considered contaminated ?
0.03mg/m3
When will the meter give you a “high concentration” readout?
Sample values above 999 ųg/m3 (0.999 mg/m3)
In sample mode-how long will the meter run before it will provide a reading?
16 sec
In survey mode- how long will the meter run before it will provide a reading?
The meter will run continuous and will provide a reading every 2 sec
True/ False the meter detects vapors only.
True
After turning the meter on about how long does it take to warm up?
About 5 min
A full battery will give about how many hrs of run time?
24 hrs
How long should the battery take to recharge to a full charge?
3 hrs
Where is the sensor saturation level located?
Below the battery icon
If the sensor saturation bar shows full what must be done?
You must regen the sensor prior to use
How long does a regen take?
Approx 45 min
How often do regens need to take place?
After every call, the sensor is saturated, or every 30 days