AP4C Flashcards

1
Q

What are the 5 detection channels of measurement on the AP4C?

A

Phosphorus (P)
Hydrogen Nitrogen Oxygen (HNO)
CH (CxHy bonds)
Arsenic (As)
Sulfur (S)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What is the response time(s) for the AP4C detector?

A

2 sec avg. (up to 30 sec at low concentration)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What type of battery does the AP4C use?

A

Lithium Ion Non-rechargeable battery/no standard “D” cells

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What’s the technology of the AP4C?

A

Flame Spectrometry

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

How do you perform the AP4C weekly check?

A
  1. Check the kit/meter for damage/ missing accessories.
  2. Install batt pack with batts into end of AP4C
  3. Insert hydrogen cyl. Into backside of handle(align pins to 12/6 position) turn the cyl. Clockwise to the “ON” pos.
  4. Listen for the “Pop”- look for the “Wait” light to display.

5.wait for “Ready” light to display.

  1. Place sound clip in.
  2. Identify channels.
  3. Preform confidence test using household ammonia-HNO Channel response.(only hold NH3 near tip for a few sec- DO NOT SATURATE)
  4. Let unit clear all alarms.
  5. Use S4PE heater.
  6. Let meter clear all alarms.
  7. Turn hydrogen cyl. Counterclockwise-remove and store.
  8. Remove Batt pack/store in tank.

14.document weekly check off.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

How do you operate the S4PE heater?

A
  1. Insert battery.
  2. Place “black” tip on S4PE/ press trigger to activate heater/ verify the light illuminates and release.
  3. Remove battery pack and store.
  4. Remove tip from S4PE (Let Cool), place in case.
  5. Place cover over tip of the S4PE and store in case.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

First LED light is what color?

A

Yellow

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

LED lights 2-5 are what color?

A

Red

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

LED blinking means

A

Maximum concentration reading

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What are the status LEDs in the center of the channel board?

A

Fail: detector not working
Wait: initializing/no flame
Fail blinking: detector may need servicing
H2: low hydrogen flow
Bat: Low power level (change batt)
Ready: detector is ready

How well did you know this?
1
Not at all
2
3
4
5
Perfectly