Flows Flashcards
Before start FO flow
- ) Pressurization (set landing field elevation)
2. ) Altimeters (set on your side, and perhaps the ISI)
Push/start FO flow
- ) V-speeds (set v1, vr, v2, and vt. May be done by captain)
- ) Fuel pumps (push to arm)
- ) Bleeds/packs
After start FO flow
1.) Bleeds/packs
2.) Anti-ice (as required)
3.) Probes (heated)
4.) Thrust reversers (arm)
5.) Transponder (set)
—————————————————————-
6.) Flaps (set)
7.) Flight controls (check, except rudder as the captain does that)
Before takeoff to the line FO flow
1.) Flight attendants (make a PA to let them know were getting ready to depart)
Before takeoff below the line FO flow
1.) Fuel crossflow (manual mode, to inhibit auto cross flow on TO)
After takeoff PM flow
- ) Thrust
- ) Fuel crossflow (turn off manual mode)
- ) Thrust reversers (off)
- ) Sterile cockpit
In range PM checklist
- ) Flight attendants (let them know were preparing for landing)
- ) Pressurization (make sure landing elevation is set)
- ) Landing data
- V-speeds input
- Approach set in FMS
- Correct frequencies set on both pilots sides, but no in active, only in standby
In range PF flow
1.) Briefings (arrival and approach)
Before landing PM flow
1.) Thrust reversers (armed, after flaps 45)
After landing FO flow
- ) Anti-ice (as required)
- ) Probes (as required)
- ) Flaps (up)
- ) Radar (off)
- ) Transponder (as required)
Shutdown FO flow
- ) Anti-ice (off)
- ) Fuel pumps (de-arm)
- ) Transponder (set to standby?)