Engine Start Procedure

Question 1

Engine Start Procedure

Answer 1

Select the secondary engine indications ….. (F/O)

Question 2

Select the secondary engine indications ….. (F/O)

Answer 2

Air conditioning PACK switches ….. OFF (F/O)

Question 3

Air conditioning PACK switches ….. OFF (F/O)

Answer 3

Start sequence ….. announce (C)

Question 4

Start sequence ….. announce (C)

Answer 4

Call ‘START ___ ENGINE’ (C)

Question 5

Call ‘START ___ ENGINE’ (C)

Answer 5

ENGINE START switch ….. GRD (F/O)

Question 6

ENGINE START switch ….. GRD (F/O)

Answer 6

Verify that the N2 RPM increases ….. (C, F/O)

Question 7

Verify that the N2 RPM increases ….. (C, F/O)

Answer 7

When N1 rotation is seen and N2 is at 25%, or (if 25% is not possible), at maximum motoring and a minimum of 20% N2:
- Note: Maximum motoring occurs when N2 acceleration is less than 1% in approximately 5 seconds
- *CAUTION: Do not apply rotational force when moving the engine start lever
- Engine start lever ….. IDLE detent (C)

Question 8

When N1 rotation is seen and N2 is at 25%, or (if 25% is not possible), at maximum motoring and a minimum of 20% N2:
- Note: Maximum motoring occurs when N2 acceleration is less than 1% in approximately 5 seconds
- *CAUTION: Do not apply rotational force when moving the engine start lever
- Engine start lever ….. IDLE detent (C)

Answer 8

Monitor fuel flow and EGT indications ….. (C, F/O)

Question 9

Monitor fuel flow and EGT indications ….. (C, F/O)

Answer 9

At 56% N2, verify that the ENGINE START switch moves to OFF. If not, move the ENGINE START switch to OFF …. (F/O)

Question 10

At 56% N2, verify that the ENGINE START switch moves to OFF. If not, move the ENGINE START switch to OFF …. (F/O)

Answer 10

Verify that the START VALVE OPEN alert extinguishes when the ENGINE START switch moves to OFF ….. (F/O)

Question 11

Verify that the START VALVE OPEN alert extinguishes when the ENGINE START switch moves to OFF ….. (F/O)

Answer 11

Call ‘STARTER CUTOUT’ ….. (F/O)

Question 12

Call ‘STARTER CUTOUT’ ….. (F/O)

Answer 12

Monitor N1, N2, EGT fuel flow and oil pressure for normal indications while the engine accelerates to a stable idle ….. (C, F/O)

Question 13

Monitor N1, N2, EGT fuel flow and oil pressure for normal indications while the engine accelerates to a stable idle ….. (C, F/O)

Answer 13

After the engine is at stable idle, start the other engine
Note: The engine is stable at idle when the EGT start limit redline is no longer shown