Brainscape's Knowledge GenomeTM

Browse over 1 million classes created by top students, professors, publishers, and experts.


See full index

Apparatus Tech material > Engine 410 Specs > Flashcards

Engine 410 Specs Flashcards

1
Q

What is the length of E410?

A

30 feet 3 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What is the height of E410?

A

9 feet 8 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What is the width at the mirrors of E410?

A

9 feet 6 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What is the width at the steps of E410?

A

8 feet 9 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What is the weight of E410?

A

43,500 lbs

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is the manufacturer and year of E410?

A

2017 Pierce Enforcer

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Demonstrate how to safely tilt the cab and access the engine compartment.

A

Chock the wheels, secure all items in the cab, secure SCBA with seatbelts, turn the battery on, turn the ignition on, make sure there are no overhead obstructions, make sure there are no obstructions on the front bumper, have a spotter watch, raise the cab

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Describe the process for manually tilting the cab.

A

Chock the wheels, secure all items in the cab, secure SCBA with seatbelts, turn the battery on, turn the ignition on, make sure there are no overhead obstructions, make sure there are no obstructions on the front bumper, have a spotter watch, remove bar from behind the drivers seat, make sure that the switch is in the raise position, make sure the pressure bleeder is closed using the notched end of the bar, place the bar in the hole, start pumping.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Where is the cab tilt fluid reservoir?

A

Drivers side under the batteries

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What type of engine does E410 have?

A

Detroit DD13

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What type of engine oil does E410 and at what capacity?

A

40 quarts of 10W40

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Identify all the locations where you can check the engine oil level.

A

The most accurate way to check the oil is to check the dipstick with the unit on a level surface while the motor is cold.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What is the normal operating pressure for the engine oil?

A

20-60 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What type of transmission does E410 have?

A

Allison 4000 EVS

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What type of transmission fluid and at what capacity does E410 take?

A

39 quarts of Trans-synd

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Identify all ways to check transmission fluid.

A

The most accurate way is to check the dipstick while the engine is running on a flat surface after the vehicle has been driven and shifted through all the gears. You can also press the up and down arrows on the transmission control panel to receive a code.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

How many speeds is the transmission?

A

6

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

What type of power steering fluid and at what capacity does E410 take?

A

4 quarts of ATF

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
19
Q

How do you check the power steering fluid?

A

The most accurate way is with the dipstick and the vehicle on a level surface. There is also a sight glass that indicates proper level. The command zone will indicate if the level is OKAY.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
20
Q

Identify the power steering pump.

A

On the inside of the drivers side frame rail underneath the air compressor.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
21
Q

Identify the location of the starter.

A

Officers side under the turbo.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
22
Q

What type of coolant and capacity in quarts?

A

56 quarts of Extended life coolant.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
23
Q

How do you check the coolant?

A

Check with a cold engine on a level surface removing the cap and looking in the/sticking finger in to verify the correct level. There is also a sight glass. The command zone/dash will indicate temperature.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
24
Q

What is the normal operating temperature of the engine?

A

190-230 degrees

25
Q

What is the normal range of the voltmeter?

26
Q

How many batteries does E410 have?

27
Q

How many spark plugs does E410 have?

28
Q

Identify the fuel separator.

A

A fuel water separator is on the drivers side of the unit after the battery bank

29
Q

Where is the alternator on E410?

A

On the officers side of the unit in front of the engine

30
Q

Identify the location of the voltage regulator.

A

Right in front of the alternator

31
Q

What is the air pressure for the tires?

A

100 PSI in the front, 105 PSI in the rear

32
Q

Show where all the air pressure indicators are for the system.

A

The dash has a front and rear gauge for the air pressures. The command zone will indicate when there is a low air alarm.

33
Q

Where is the air compressor located?

A

On the drivers side

34
Q

How many air tanks does the engine have?

A

Three, one for the air horn and two for the brakes

35
Q

What is the normal operating range for the air brakes?

A

90-120 PSI

36
Q

At what pressure should the low air alarm sound?

37
Q

At what pressure should the parking brake pop?

38
Q

What is the governor cut in and cut out pressure for the airbrakes?

A

100-120 PSI

39
Q

Identify the engine brake control switch and describe its use.

A

Located on the right side of the steering wheel there is an on/off toggle switch. To the right of that there is a high/medium/low switch. Engine brake should not be used during inclement weather.

40
Q

Identify the drop chains control switch and describe their use.

A

To the right of the steering wheel. Two stage switch (so you cant press it by accident). Drop chains can be used in up to 6 inches of snow at a maximum speed of 30 miles per hour.

41
Q

What type of pump does E410 have?

A

Waterous mid-ship 1509 GPM single stage centrifugal pump

42
Q

What is the pump capacity?

A

1509 GPM at 150 PSI

43
Q

What is the pump rated at 100%, 70%, and 50%?

A

1509 GPM at 150 PSI
1053 GPM at 200 PSI
750 GPM at 250 PSI

44
Q

Does the vehicle have a manual pump shift override?

A

Yes, there is a handle on the bottom right corner of the pump panel that is labeled as such. The air actuator needs to be put into neutral, then the handle can be pulled, air actuator all the way down then the transmission will still need to be put in gear afterwords.

45
Q

What is the size of the water tank?

46
Q

What type of foam system does E410 have?

A

No foam system. It has an inline foam eductor which must be 50 feet from the pump panel. It also has two 5 gallon buckets of foam concentrate of thunderstorm AR-AFFF 1-3%,

47
Q

What type of foam and how much is carried?

A

Two 5 gallon buckets of thunderstorm AR-AFFF 1-3% class B foam

48
Q

Where is the foam drain?

A

There is none

49
Q

Identify all the intakes on E410.

A

One front bumper, two mid-ship officer side intakes, one rear intake, one pump panel hose line intake, and a direct fill from the top. A total of 6 intakes.

50
Q

What is the intake relief valve pre-set at?

A

150 PSI for the front, side, and rear intakes.

51
Q

How many discharges are there?

A

One front bumper, two crosslay, two LDH discharges, one booster reel, one deck gun, three rear discharges for a total of 10 discharges

52
Q

How many 2.5 inch discharges are there?

A

One front bumper and three off the rear.

53
Q

How many 1.5 inch discharges are there?

A

Two crosslays

54
Q

How many 3 inch discharges are there?

A

One deck gun

55
Q

How many 4 inch discharges are there?

56
Q

What are the lengths and starting pressures for the preeconnects?

A

Front bumper is 150 feet and starts at 95 PSI
Front crosslay is 200 ft and starts at 110 PSI
Rear crosslay is 250 feet and starts at 125 PSI
400 ft line off the rear is 170 PSI
200 feet of 2.5 inch 1 3/16 tip is 86 PSI
200 feet of 2.5 inch 1 1/4 tip is 105 PSI
Deck gun for tips sized 1 3/8, 1 1/2, and 1 3/4 starts at 110 PSI
Deck gun for two inch tip is 120 PSI per hydraulics manual

57
Q

Show all places where the oil pressure is given.

A

Gauge cluster, command zone, lights under the throttle

58
Q

Show where the engine cooler temp is found.

A

Gauge cluster, command zone, lights under the throttle

Apparatus Tech material (14 decks)

Brainscape helps you reach your goals faster, through stronger study habits.
© 2025 Bold Learning Solutions. Terms and Conditions