AW 139 Audio Flashcards
What is the CAB push button on the Audio Control Panel used for?
b. To connect the PLT or CPLT Audio Control Panel to the Cabin Audio Controller
The Cockpit Area Microphone is installed:
b. On the instrument panel above the Pilot’s PFD
The Voice Recorder can record some audio inputs:
b. The pilots´ voices and cockpit area audio
When the Test push-button on the Cockpit Control Unit is pressed
a. The BIT initiates, the two yellow LED’s ( CVR/FDR FAIL ) illuminate for eight seconds and then extinguish
When the Erase push-button is pressed
b. The Voice Erase Cycle is initiated only if the A/C is on ground and both the Engine Mode Selector switches set to OFF
There is the primary and the backup radio tuning functions:
b. The primary through the MCDUs and the backup through the CCDs
The VHF system automatically transmits
a. A time-out signal after 2 minutes to prevent blockage of a communication channel
If inside the VHF module the over-temperature condition exists
b. The NIM controls the two MRC cooling fans to keep the MRC temperature within limits
Through the Audio Control Panels
a. The pilots receive the warning audio inputs
The Public Addess (PA) push-button when pressed
b. Connects the pilots to a third-party passenger address system
The Push-to-talk (PTT) operation is provided
c. Through the cyclic activated switch or the foot activated switch
The backup mode is set
b. If the Audio Control Panel power fails
MRC no.1 is located
c. In the left side of the nose compartment